Kundenbewertungen für VEVOR Präzisions-Gehrungsanschlag für Tischkreissägen, Standardschlitz, 3/4 x 3/8 Zoll, 61 cm Gitter

The miter gauge by itself is acceptable. The problems are with the fence. The fence face is not smooth. There is a ridge at the lower portion of the fence causing the front portion of thinner materials to rise up off the table saw surface when held tightly to the fence face. If all you were cutting was 2x4s you would be fine but my needs are for thinner stock. The other issue is with the ruler scale on the fence. Since there is no way to adjust/compensate for the distance between the fence edge and the blade you will always have to do the mental math of adding that distance on to the desired measurement. This issue makes the ruler unusable/not easy to use. For these reasons I believe this tool will sit in my shop collecting sawdust. I would like to return this item but after investigating the return policy I discovered that I would be charged a restocking fee and have to pay return shipping. This is never mentioned until you attempt to return an item. So the 30 day moneyback guarantee has strings attached. I wont be buying anymore items from Vevor.

I did not receive this order. I received a message that it was damaged in shipping and returned to shipper. The tracking shows that it was returned to shipper.

Pushing a longer board it is way too easy to override the spring pressure of the balls and springs, that keep it t tensioned in the slot. It's hard not to deflect a couple of degrees as you push it. Basically if you need the fence your board is too long for this miter gauge, you will deflect the angle and get an inaccurate cut. When I first set it up using a five cut method on a 12" piece of plywood. It wound up at an almost perfect .oo2" on the last cut, right out of the box. As soon as I cut a 6" board 30" long, the cut was about . 020 out of square. Huge waste of money! Find a better miter gauge that doesn't use springs. This might work if you were only cutting short pieces for a segmented ring. Other than that it's junk for standard use. P.S. The problem was not my saw top. It shined up, smooth and very slick. I even made a conscious effort to try and keep it from twisting by trying to counteract the twist as it made the cut. It helps but it's impossible to do repeatedly. Please find one that does not use springs for tension.

Never received item. Vevor camcelled order waiting on refund.

This thing flexes too much, i dont trust it as square