Kundenbewertungen für VEVOR Plasmaschneider, 50 A berührungslose Pilotlichtbogen-Plasmaschneidgerät, Digitalanzeige IGBT-Wechselrichter mit 2T/4T-Funktion & einstellbarer PA/PT-Zeit für Heimreparaturen, Werkstätten

Good and easy to use

The clear hoses used inside for the air pressure sensor are cheap and leaked from the get go, I replaced it with softer rubber vacuum line and that took care of problems,after that problem was taken care of it has worked very well ,setup is easy and it cuts very nice and I'm very happy with it for the price hopefully it lasts!

I've not used this tool yet for any major applications. But over all assembly was easy.

Suite à quelques utilisations je suis arrivé au moment de remplacer les consommables et malheureusement lorsque je les remplace par les consommables fournis le poste ne fonctionne plus j'en ai donc commandé sur un autre site et idem je ne sais pas où avoir des consommables identiques à l'origine monter sur la torche.

Przecinarka robi co ma robić, nie ma się do czego przyczepić- jedynie dwie rzeczy są denerwujące : czas chęcia to tylko 6 sekund - strasznie irytujące, oraz jeszcze większy minus- nie pracuje na przedłużaczu 2 żyłowym musi mieć 3 żyły.

Received this unit today, set it up and tested it. Instructions beyond labeling of components are non existent. Troubleshooting is for a welder! After a couple of hours of screwing around, I found that 4 of the 5 tips I was shipped were defective and produced only a very weak spark. Luckily one tip worked so I could verify that the unit was operable. The electrodes also look very cheap, so I would recommend shopping for some higher quality consumables right away, and you'll have to Google the settings for air pressure, 2T vs 4T operation, current settings etc. The unit seems ok, but it's frustrating trying to troubleshoot multiple faulty components on a new unfamiliar item. Picture of my faulty parts below for reference.

premiere utilisation et la torche crache des flammes par la gachette ,je viens de poser reclammation on verra bien , pour le moment c'est 1 etoile et zero si je pouvais ,suis degouté

Ha funzionato bene per le prime ore, poi ha iniziato a interrompersi a metà taglio. Si è arrivati ​​al punto in cui era difficile mantenere stabile l'arco plasma... Ho comunque finito il lavoro, ma consiglio una marca più costosa, come Telwin, se si deve tagliare molto acciaio. Quando ho finito di tagliare la vecchia caldaia a gasolio, non riusciva più a eseguire tagli lunghi più di un centimetro prima di interrompersi, anche dopo aver sostituito gli ugelli della torcia.

It does fine with small cuts but if youre trying to make long cuts it tends to overheat and shut off. Ended up buying an Arc Captain Cut65MP and am so happy I did.

Leider liefert das System nur 33 A Ausgangsleistung und keine 65 A - wie versprochen Nach einigem Hin und Herr mit der Hotline wurde der Kaufpreis dann aber rückerstattet