Kundenbewertungen für VEVOR Palettengabel 1090x70x230mm Gabelträger 907kg Tragfähigkeit Gabelzinken 109cm Gesamtlänge mit 76cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

The product arrived and is what was expected. But, much to my dissapointment only half ot the required hardware, 2 of the 4 nessecary 20mm bolts, were included. When I coresponded with Vevor Customer Service, and asked to have those bolts sent, I was told that Vevor did not have them, nor could they procure them, and I was offered a partial refund. I took the refund, and eventually did find the proper 8.8 Grade bolts, but as I was required to invest my time and effort, my frustration over this purchase grew, hence the 2 of 5 star rating.

They are a little flimsy but work ok for what I need to do.

It was built really well but they never put the screw rods in the package and you need those to stabilize the forks on whatever you mount them to, and they wouldn’t send me replacements

I would not by again. Weld holding stabile bar broke 1st time I used them to pick up 4 empty wooden pallets. Very disappointing.

Was moving rafters and some how bent one of the blocks that tighten it down with my 35 hp tractor

I was disappointed when I got these. The pads used for the mounting screws are just nuts loosely threaded on. When you go to tighten them, the nuts spin on the screw and will move up. When you loosen, the nuts fall right off. Very cheap design. If you are putting the forks on one time and leaving them, it would be okay. But if you are constantly taking them on and off, it is a big deal.

The clamps do not stay tighten, not a very good set up. When lifting, the screws become loose and slides off my bucket, if you’re needing forks, just buy an actual pallet fork attachment. I would not recommend these.

Verry dissatisfied as it has not held up and I have had to constantly straighten and reinforce to just get by, am looking for alternative.

I tried these forks on the bucket of my tractor. They were very hard to tighten and grab the Steele of the bucket. Once tight, they became loose again.

Very bad. Weld failed using it once!