Kundenbewertungen für VEVOR Palettengabel 1090x70x230mm Gabelträger 907kg Tragfähigkeit Gabelzinken 109cm Gesamtlänge mit 76cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

Love these forks. I also bought the fork extensions, vevor needs a set fork the bucket forks. I modified mine. See the photo below.

10/26 fourche 3 point. Ces Cat1 alors fait pour petit trateur. Assez solide. Mais les attache du bas son trop basse et ne dessans pas assez. Je doit le modifier! Kubota BX23S 2022

Prima aan gekomen .Alleen ontbreek er een pen voor de hefinrichting Jammer moet die gaan kopen hier op het drop hoop dat ze er een hebben

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate

I did t rate it hi because its not strong enough for my use. If you're just going to make straight pics its fine but it twists easily and comes apart easy. I will find a stronger one. I wasted my money on this one

The center bar broke right away other than that work well

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

It work