Kundenbewertungen für VEVOR Motorständer Motorhalter 680 kg, Motorständer Klauenheber Getriebehalter, Motorheber Kfz-Werkstatt mit Rädern & 508 mm Griff, Bewegliche Motorheber Motorkräne Reparaturwerkzeuge Klappbar

It's ok. The stand I feel is overrated for weight of a motor. The up arm needs more lean back to handle the weight. I should have gotten the next one up.

Good price, cheaply built which was expected. Wheels don't roll well, paint is mismatched. Had to pop out the metal where it wasn't stamped out fully. Engine tilts down because the build materials are weak. Definitely wouldn't try to max capacity. This is just a 5.3 engine.

Hardware was incomplete but a trip to ace fixed it. I like it when I don't have to do that and it comes with everything. Instructions were bad, for the bolts it did come with they should come separated not thrown in one bag, very hard to figure out what goes where

These buckle under the weight of a small block Ford with just crank and rods. I'm afraid to assemble a full engine on this because it is very unstable. The arms don't work well for sbf or sbc. I'm going to beef it up some and use. I bought 2 of these not expecting much.

Stand is ok. However I ordered another one from Temu for half the price and it's the exact same vevor stand

I ordered this to do work on engines as I am a mechanic. I thought it was going to be an okay stand for smaller engines, vevor described this item too good to be true but starting with the paint, it came pretty scratched up with the paint peeling and chipping.. assembly instructions are misspelled and horrible. It was okay as the tool being pretty straightforward so I ignored the instructions and as im putting it together I noticed that im missing hardware.. also some of the bolts and nuts stripped before I could tighten all the way.. now I dont trust any of the hardware and will have to buy all new bolts and nuts with a better quality. Not to mention in a few months I will have to repaint before it starts to rust, I hope the welds are strong enough too or else I will also be welding it.. I should've just made my own, only if I wouldve known.. im very disappointed as this is the first item I buy from here

The ultrasonic cleaner was damaged from shipping because it was dropped on its edge. Vevor would not replace the damaged one and I had to go back and forth for a week trying to get a replacement. This is the first time I had to deal with an issue with Vevor and it was a horrible customer service experience. They went back and forth emailing that they need more picture, and then a video, and then they would give me $30, then $60, as reimbursement and doubling it every email. All I wanted was a new undamaged ultrasonic cleaner which is what I paid for. After a week of fighting they finally reimbursed me. I would give 0 stars if I could...

This thing is hard as anything to spin any engine on it….i would never repurchase sadly…it does get the job done though

Put a Duramax on this stand you will find out quickly it is garbage. Even with no turbo , cylinder heads or exhaust manifolds you can’t rotate it. It is scary dangerous to even try

Functional, but very, very poor build quality.