Kundenbewertungen für VEVOR Hochbeet Metall 2400x1200x600 mm, Pflanzbeet, Gemüsebeet, Pflanzkasten mit offenem Boden & abgerundeten Kanten, großes Blumenbeet, Kräuterbeet, ideal für Gemüse, Blumen, Kräuter & Sukkulenten

I bought it a week ago and filled it 3/4 to the top with soil. First, it was very easy to build, even though the instructions are inadequate. The finish is great and it looks good in the garden. I think there's insufficient support bracing from side to side. There's only one * shaped cross brace and the sides are starting to bulge out between the brace and the ends against the weight of the soil. I would happily pay more for 2 additional braces. I've used Vevor about 10 times and am very happy with the value and quality of everything I've received up to this point. I'll continue to be a customer but I'm skeptical about the durability of this raised bed.

I bought 6 of these to use in my vegetable gardens. To start, peeling the plastic off the panels was awful. It ripped and didn’t come off easily. Second, the metal edges are sharp! Even with the gloves that are provided, the metal cuts right through. My daughter was injured pretty badly with one of the edges just by walking past it as it was being built. Building was not bad, instructions were simple to follow. That’s probably the only pro to this product. Lastly, the beds are wobbly and not sturdy at all. Even with the center posts to keep it stable, once you add planting material, soil, etc they cave in anyway so pretty much pointless. I am actually really disappointed in these, for the price it could be better. Maybe use foam instead of the plastic sheeting covering every single inch that takes on average 2 hours to peel. Safety concerns are high with the metal sharp edges. That needs improvement asap before someone gets seriously hurt.

The 2ft deep beds are not well supported to prevent deforming from the weight of the dirt. The 1ft beds have 3 supports along the length to hold their shape but the 2ft deep have only one support in the middle. The design of this support has a central hub which will get pressed down and pull the sides in. To prevent this, you must cut a supporting piece to fit snugly under the hub and prevent it from moving. Then, slowly fill the bed from the outside edges in. Otherwise they tend to get pulled in and deformed. Otherwise, it's a good bed.

Nearly every panel is scratched. Terrible.

Not a fan of wingnuts but it went together easily enough. Problem I had is metal is too thin . Bent one just positioning it

It's very hard to keep it straight.

Je n,ai pas recu la commande

Too many seams. Picture shows no seams. Flimsy once filled. Center seperator bars pull in when dirt goes in. Making my own next time.

Hundreds of screws to install, 10, 2' panels with a very thin plastic that tears very easy and makes removing the plastic a very tedious job that takes forever to remove. I was going to order 12 of these boxes but luckily I only ordered 2 to check them out. This would be a great deal but for the plastic protective covering. I'll probably leave the plastic on them and let the sun bake them. Obviously I'll not be buying anymore.

These are very flimsy and didnt hold up at all. Terrible quality. They started bowing and bending with only half dirt, there is only one center brace and there should be 3. If I did already put all the work Into them and already filled them I'd send them back. Picture dont due it justice