Kundenbewertungen für VEVOR Hochbeet Metall 2032x1016x470 mm, Pflanzbeet, Gemüsebeet, Pflanzkasten mit offenem Boden & abgerundeten Kanten, großes Blumenbeet, Kräuterbeet für Gemüse, Blumen, Kräuter & Sukkulenten

I've bought 3 of these raised beds and like them very much. Easy to assemble, but the changed from hex nuts to wing nuts this year, which don't fit under the cross bars, so I had to bjy some hex nuts to fit.

Good product sturdy walls

Received in timely manner easy to put together as long as you have a little bit of common sence instructions is just pictures and seem vague but easy to figure out quality i feel it would be a better product if they used a thick gage metal but for what it is makes it easy for 1 person to put together and move around to where you want it located takes about 10 maybe 15 min to put together just because its held together with winners at every joint and there are 6 at every joint so bit time consuming other wise overall nice look feel like it will last and I feel it was at a reasonable price

Ce plate-bande de jardin en métal est fait de sections métalliques recouvertes d'un film plastique et boulonnées ensemble avec 128 boulons et noix papillons au total. L'assemblage est assez simple mais fastidieux. Au centre est inclus un support métallique constitué de 3 branches de chaque coté pour solidifier les parois. C'est bien, mais pas assez car avec le poids de la terre, les parois ont tendance a gonfler dans le bas des panneaux qui n'ont pas cette retenue en métal. A part ce défaut, il semble de bonne qualité, le temps le dira. J'ai empilé environ 8 a 9 pouces le fond avec des débris de jardin tel que des feuilles, de petites branches, épines de pin, etc... pour ne pas avoir a emplir avec 24 pouces de terre, ce qui serait un peu trop lourd et pas nécessaire. De plus ces débris vont composter avec le temps et vont apporter des nutriments aux plantes. J'ai mis environ 2 pouces de roche 0-3/4 dans le fond recouvert d'une toile géotextile; puis j'ai installé un cadre en bois traité fabriqué avec des 2 x 4 et installé la plate-bande dessus. Je suis satisfait du produit pour l'instant.

Appears to be good quality at a reasonable price.

Give yourself at least an hour per box for assembly, and an extra pair of hands makes it go faster. When assembling, the slightly shorter pieces are for the ends, longer pieces are the sides. Every piece of the metal sides and ends has a plastic film on it that you'll want to remove. It's very hard to spot. I didn't notice it until I had the first one completely assembled, but by then it's too late to remove cleanly... remove before assembly (it's very satisfying!). I'm sure the sun will destroy the protective film in short order and make it look ugly. Also, these 24" deep boxes will be fine for dwarf fruit trees, berry vines, asparagus, potatoes and sweet potatoes, but they're way too deep for anything else, just a waste of valuable soil, IMO. The only benefit I see is that because they're taller, they're easier to access if you have trouble bending low to work your garden. Other than those things, these are nice looking beds and I plan to fill my garden space with them (the 12" high ones mostly).

I was impressed with the quality of the metal in these raised beds. They were easy to put together and sturdy once put together.

They look great, but you need to prop up the centre spreading bars. I used bricks, 2x4s and anything that would keep the walls from sucking in. Rigid 4 foot bars would be better.

I bought two of these for our backyard garden to replace rotten wood raised beds. I’ve had them for a year and they are holding up well. They were a bit of a pain to assemble and the centre bars bend in the middle, not sure why they aren’t straight and more sturdy to support the beds. However once on level ground with soil in them, they hold up well. You need a lot of soil to fill them, I suggest filling your beds with cardboard, branches, leaves as a filler base before putting soil in. Save some money.

" It takes only 15 minutes to set up with no extra tools needed", more like 15 minutes to take the bloody plastic protection film off. Humour aside, it did take more than 15 minutes to put to set up, but it goes together pretty easy. Only needed instructions once, as the rest was pretty intuitive.