Kundenbewertungen für VEVOR Gehrungsanschlag, Standardschlitz 19 x 10 mm, Aluminiumlegierung mit 48-89 cm Rasterung, 15 Winkelanschlägen, verstellbarem Kolben und abnehmbarer Scheibe, für die Holzbearbeitung

Great addition to my table saw. Better than the one that came with the saw. For the price, you can't go wrong.

The Miter Gauge is really precise and simple to set up. The only thing I'd like if it had a possibility to have support for wider stock to be held up by something when you extend it and perhaps to have something at the bottom of the fence so that it would not glide on the table saw metal on metal but rather some kind of softer material that would not damage the table saw surface.

Very solid build. Assembly quality and precision are generally very good, some minor misalignment's here and there, within 0.2 degree precision, but at extreme angles expect 0.4 degrees, I bought 3 sets, there are slight variations between them. On a fine tuned saw you can expect very high quality results with this Vevor miter gauge. The grater is extendable up to 35"/890mm that's very impressive. Simple repeatable cuts with the built in stop, which has micro adjustment. It can be difficult to read the millimeter measurement as it is partly hidden by the pointer, Inches are easy to read though. The pivoting screw in the angle meter, has a slight wiggle 0.1 degree, its as good as it gets with the design used. I would buy again.

nice precision tool

Excellent build quality. True out of the box. Best bang for your buck miter guage on the market. The only feature I wish I would have is the ability to use a sacrificial fence.

Nickel, content de mon achat, les angles sont juste je pense que la qualité y est, je verrai dans le temps

Nice product, great price need improvements to work. need to have UHMW, Acrylc tape attached to the bottom fence and the miter gauge so they will not scratch the table of the saw. the second issue is the metal part that goes to the miter saw slot. when inserted to the miter slot the front is too low, and the miter gauge is laying on the table, so part of it is higher than the table. Adding a flat metal between the miter gauge and the part that goes to the miter slot caused it to be flat.

Product needs to be a little bit more rugged. As soon as I got it, it was easily cut. If there were more instructions on how to use and be careful with it would be much better. Thank you for your product. I do like it a lot.

good for the price

Manca la possibilità di fare tagli inclinati a 45°