Kundenbewertungen für VEVOR Gehrungsanschlag, Standardschlitz 19 x 10 mm, Aluminiumlegierung mit 48-89 cm Rasterung, 15 Winkelanschlägen, verstellbarem Kolben und abnehmbarer Scheibe, für die Holzbearbeitung

Einfache Montage gleich einsatzbereit

Excellent value. BUT make sure that your table guide slot is the same size as the runner

Atrezzo molto ben fatto molto preciso e semplice da utilizzare. Arrivato in una confezione molto protettiva. In base al mio utilizzo (hobbystico) lo consiglio

A bit sloppy in my t-track but after some adjusting it was perfect

Nice unit and well built. Accurate straight from factory. My stopper had some machining issues but I quickly received a replacement so I can say that the customer service works very well too. The red indicator of the stopper could be better. I switched it to other side of the stopper hinge to get the gauge away from blade. The t-rail bar should be replaced with one that has eccentric tightening mechanism. The current one is annoying to adjust, needs a lot of threadlock to stay tight and those little ball bearings clog by saw dust. The tension spring in them is so soft that they also need to be basically tensioned until the ball cup scratches the t slot.

Came out of the box as square as any of my current squares allow me to measure… could use a longer miter bar as it gets a little squirrelly near the front of the saw, keeping in mind that my saw doesn’t allow me to use the stabilizer disc underneath the bar… slot is too narrow. Will try to find a smaller disc to use and see if that helps. Micro-adjustment assembly is nice. Extension wing is helpful but has a bit too much play in it at full extension. Overall better quality than expected for the price point.

Not the size for what I Needed it doesn't really fit my power saw table.

Die Einstellung der Schiene mit seitlichen Schrauben ist nicht mehr Zeitgemäß und umständlich! Da sollte man alles von oben wie bei anderen Herstellern einstellen können. Produkt ist aber soweit o.k.

Välbyggd, andas kvalitet till ett bra pris. Har kapat flertalet goner med bra resultat Rekommenderas starkt.

I bought this a while ago and have been waiting to get my table saw set up properly and I finally got it together a few weeks ago and the miter gauge was really good for the price . Beats the factory one that came with the saw.