Kundenbewertungen für VEVOR Schraubzwingen-Schraubstock 160 mm, Tischschraubstock 160 mm, Bench Clamps 150 mm, Metall Professionelle Gusseisen Schraubstock für Säulenbohrer Breite Backen

Not bad for the price

The vice seems solid.

Not a Kurt vise. Made alot cheaper, but you can buy 5 of these for the price of a Kurt vise. Depends on what you need them for. They are alot lighter . Good for certain quick jobs.

No idea why Vevor suddenly asked me to 'review my recent purchase', I bought the vise in 2021! It needed stripping down, cleaning and deburring to start with. I then had to scrape the bottom surface flat as it rocked 0.002 corner to corner as received. The moveable jaw lifts quite significantly as the vise is tightened, and no adjustment on the poorly machined ball socket seems to help. It is possible to tap it down as you tighten the jaws but that makes it a bit of a pain when setting up. The jaws are perpendicular to within a few 10ths and are mostly straight, so tramming in is possible so long as you only use a half-thou indicator and don't look too closely. At the end of the day, it's perfectly good for day to day work, and with a bit of imagination you can do some reasonably accurate stuff with it if you put the time into setting up. Good enough for a home shop, and well worth the small amount of money it cost.

Works good couldn't ask for better does what it's supose to do and more best price best quality of all them

Bien vérifier les dimensions. Elle est très grande

If your a farmer and need a vice for your mill to make parts for your stuff, this will do the trick

The cast recesses for hold-down had large areas of razor sharp jagged areas, a serious injury risk. No de-burring was done anywhere, even the chamfers needed de-burring! The whole unit was full of casting / machining grit, cast flashing and required a complete tear-down and degrease / wash out and finishing with a rotary burr. The machined recess for the thrust washer had a large sliver of metal which caused jamming. The fixed jaw had 0.15mm of vertical run-out.

Etau mal fini avec plein de bavures d'usinage ainsi que de la rouille. Voir photos

These are ok light duty vises for the price, if you need just one. However, nothing is consistent on them, they do not match as sets. We bought 6 to use as a set. None match. Every one of them will have to be re-machined, the hard jaw thicknesses, vise height, key slots on bottom. Considered sending them back. We will probably have to spend a few hours on each one to make them match. We have been satisfied with the cost/quality on vevor products untill this purchase.