Kundenbewertungen für VEVOR Schraubzwingen-Schraubstock 125 mm, Tischschraubstock 125 mm, Bench Clamps 140 mm, Metall Professionelle Gusseisen Schraubstock für Säulenbohrer Breite Backen

Very heavy and bigger than I expected Good quality and it should last a life time

Alles IO muss engrated werden

This vice is very good for the price compared to more expensive units. the one thing I would say is it needs to be stripped down and cleaned and aligned. The jaws on the one I received were not level and there was quite a lot of swarf in the thread. Best to clean and align it to prevent wear. Apart from that an excellent buy for the price.

I'm 95% satisfied with this vise. My only complaints are there are some very sharp edges right out of the box that should have been finished better, and the jaws are NOT hardened (common complaint it seems.) Past that... it works perfectly for my drill press, the price is definitely right, and other than my two complaints, it is put together very well.

solid bit of kit. Probably not as precise as a kurt vice but they cost in the thousands. I'm happy with this one.

Cet étau est de bonne facture et assez précis. Il est robuste et serre bien fort les pièces. Il suffit amplement pour le travail de bricoleur et hobbyiste.

Vice is nice but you have to clean it or the threads will lock up as the drilling residue binds up the threads.

More than expected, excellent accuracy for my old machine. Only minus was the marking of the scale, there is no drawing or Mark that you could see the degrees...

Degelijk, ziet er goede kwaliteit uit. Klauwen schuiven soepel weinig speling Bij veelvuldig gebruik zal het uitwijzen dat het top is.

The 5inch vice arrived promptly and surprisingly undamaged given it's weight. Unpacking it I noticed immediately that the finishing was not great but 20 minutes with files took off the sharp edges. Out of the box the jaws aligned well and the action was smooth bit I felt that there were some small modifications that would make it better. Firstly I didn't like how the lock collar just screwed onto the threads so I made a brass split collar to replace it. Also the bearing surface for the back of the lead screw had not been machined and caused a little binding. I used a dremel tool to flatten this and then added thrust bearings on both front and back surfaces to make it easier to use. Overall this product is, with a little TLC, value for money.