Kundenbewertungen für VEVOR Stemmvorsatz für Bohrmaschine, 4 Modellbohrer, Vierkantlochmeißel-Set, Tischbohrer-Positionierungsset, Stemm- und Zapfenwerkzeuge mit 5 Buchsen, für Holzbearbeitungs-Stemm-Zapfenbohrmaschine

It did not fit my drill press. I had to make minor tweeks for proper fit. by usineing a plastic soda botel I cut a shim to take up the excess space

Too slow in Australian hardwoods, and alignment between chisel and drill not precise, square holes have one side drilled away. Was faster to make mortises with chisel.

This is a very well built tool. Sadly this does not fit many drills. They say it does but, Not it does not. I would not recommend this unless you get the measurements from them and compare it with your drill or drill press.

I was hoping that this tool would assist with creating deep mortises in some brush box timber. After reading the simple instructions I found that I needed to buy mortise chisel sharpening cones as they came blunt. Would be good to have the sharpening cones in the set. After buying the sharpening cones and sharpening as best I could, noting that the sharpening cones were not the same angle as the mortise chisel, I still couldn't create a mortise using my drill press.

Tried multiple times to use this on my drill press. I tuned the drill press, made sure everything was square, there was no play in the spindle (