Kundenbewertungen für VEVOR Schweißtisch klappbar 76,2x50,8cm Werktisch 181kg Tragfähigkeit Höhenverstellbar von 63,5 bis 81,3cm Einstellbarer Winkel 0°/30°/90° Werkbank Kohlenstoffstahl Werkstatttisch mit Rädern

I had to do a bit of altering to make it work. I also had to wire the four ends of the rubber feet to keep the rod from falling off. Replaced the thumb screws for the tilt with regular bolt and nut to keep it steadier. Then attached a hanging wrench in case I decide to fold it up. Once completed, it works well.

For me and my business, it works well, just the right size and cheap price. Minus for the weak welds on the nuts for the height adjustment that I had to remake, and why put the knobs in different directions?. I also had to drill 2 holes on one leg.

Pas évident à monter, les dessins du mode d'emploi ne correspondent pas toujours aux pièces contenue dans le kit, il faut interpréter. Il manque un dessin, on passe de l'étape 8 à l'étape 10, la 9 est manquante alors que la numérotation des pages se suit. Les pièces du chariot de soudure, acheté ici aussi, étaient toutes numérotées, ce n'est pas le cas de cette table. Attention, les bords des pièces non peintes sont coupantes, elles sont brutes d'emboutissage, l'utilisation de gants épais ou, comme moi, une bonne séance d'ébavurage permet de minimiser le risque de se blesser. Le rapport qualité prix est vraiment correct et de pouvoir la plier pour la ranger est un plus. Encore une fois le mode d'emploi peu clair et pas à jour fait baisser ma note sur ce produit.

I'm really liking this table, I only use it ones in a while so it's very convenient to fold it away. I use a small vise that I screw to the table when I weld on it but sometimes I use it directly on the top. The table top is a little thin and it can warp if you weld gor a long time directly on it, like when you practice several beads on the same piece, no big problem. If you don't fold it away you want to buy a heavier table.

I really haven’t used it yet, too cold outside.

Over all not a bad little table . Some modifications needed to the angle adjustment it’s too easy moved .

Im happy with my\nPurchase.

Quite a solid table for the price. Two hand nuts and 8 nuts and bolts missing. Had to go to Bunnings to complete the table.

Manquais 3 boulon et ecrou de plus les patte defait seul et je pense as les roulette servent vraiment a quelque chose apart cela il semble bien on verra avec le temps

Understand that this is a very light duty table. I purchased it simply because of the price and folding ability. If you're looking for something a little more, Harbor Freight makes a smaller table. The table is easy to cart around in the bed of a truck with the welder. You know, like when a friend or relative asks for your welding services yet again. I don't expect this to last forever, but it'll do until I decide I'm not quite as cheap as I really am.