Kundenbewertungen für VEVOR Schweißdrehtisch 200 kg, Schweißpositionierer 120 W, Neigungswinkel -45° bis 90°, Drehzahlregelung 0,5–5 U/min, elektrisch & per Fußpedal, zum Schneiden, Schleifen & Montagearbeiten

My only complaint is on the packaging. It's not well protected and you can expect at least some minor damage. Mine had the legs tweaked a little and I had to do some work on it to fix it. Also one of the bushings on the acme threaded crank was broken and came out of the housing. I made another one. I had to adjust the hand crank engagement by opening up some holes. No big deal. After a couple of hours of work it was very close to perfect. For the price, no regrets. I recommend it, just be aware it might not be perfect when you get it.

ATTENTION il y a pas de passage central p our par exemple passer un tuyau de gaz pour le chambrage

merci de me transmettre la facture svp https://www.vevor.fr/user/myorder/detail?sn=24082000955714292512

Speed is too high for welding tubes 2.5" or less

I got the 10kg rated positioner, that's probably an accurate estimation of it's capacity. However, it has 2 main problems. Firstly, it's almost unusable with the gear ratio provided, it spins far too fast unless you're welding pencils or something. Luckily, that's a $15 fix by purchasing a 15rpm gearmotor and throwing away the 88rpm one that comes with the unit. Secondly, the chuck is very underrated for this positioner. It's more than a $15 fix, but I had a 5" chuck from an old lathe that I was able to adapt to this, and it suits it much better. So basically, it spins too fast and the chuck is too small. But it's so inexpensive I would still buy it again if I lost this one. One more thing that would be nice is a digital readout on your rpm so you could do repeatable procedures, but not a must-have.

It arrived with a damaged box; it works, but it's dented. I need a replacement and a refund.

I dont think they could make the arm that holds the mig gun couldn't be made any cheaper its all pretty sloppy with little tiny wing nuts that dont hold the arm still they should just make better & charge a little more ,the motor part works fine so far the timer could be a little better & it could go a little slower the speed adjustment is all over the place.

Works good for the price but definitely need to move slower wanted to use to roll out tig welded stainless fittings

Absolut unterirdisch. Kann kaum Kraft und kann nicht fein genug geregelt werden. Das ist sofort beim inbetriebnehmen aufgefallen. Eine 24h nach Eintreffen gestarteter Versuch den Artikel zurückzugeben wurde mit Verweis auf das weit entfernte Lager abgelegt. Mehr ausgeben für ein besseres Produkt ist absolut sinnvoll.

Nach wenigen Tagen Defekt konte keine Reparaturadresse finden