Kundenbewertungen für VEVOR Rohrbiegegerät, 6,35/9,525/12,7 mm Außendurchmesser, 3-in-1-Rohrbieger mit manueller Wasserwaage, 180°-Biegewerkzeug für Kupfer-Aluminium-Rohre für Autoreparaturen, HVAC-Klimaanlagen

******. Good.product.

Tool performs perfectly, bends are smooth and precise. Works well on six, nine and twelve milimeters pipes.

Buy this for your mini-split installation and avoid damaging your lines. Poorly bent lines led to leaks and a short life for my mini-split as i could not get the freon recharged so had to replace the mini-split. This tool will help you to avoid that damage.

l'envoi a été très rapide , la cintreuse est solide (métal moulé)et l'ensemble est bien fabriqué. Elle permet de cintrer des tubes en cuivre de 10 , 12, 14mm j'aurai aimé pouvoir cintrer aussi le 16mm mais c'est déjà pas mal comme ça .

Der Rohrbieger ist von guter Qualität, sehr gut verarbeiten und es war damit möglich eine 1/2 Zoll Klimaleitung 120 Grad zu biegen. Das ist bei eine Wandstärke von 0,8 mm nicht wirklich einfach ohne das die Leitung knickt. Der Rohrbieger ist perfekt für Klimaleitungen da er für die gängigen Leitungen 1/4 3/8 und 1/2 geeignet ist.

Made a beautiful 180 degree bend on 3/8\" steel fuel line. Glad to have this tool around for when I need it.

Tubing crimped a little bit when making a 90 degree bend and was a little hard figuring out how to use, but in the long run, it did the job.

This was my first time use such a tool. I had to bend 1/4 \" OD tubing. The problem was that it had very- very thin tubing wall. Well, from the web I learned to fill the tube with soap water and frees it before bending. Frozen soap water provides internal support to the walls during bending, thus preventing wall buckling or collaps at bend area. Overall tool worked flawlessly, it is solid metal build and looks and feels durable

I bought this to bend 1/2" hvac tube. The first practice bend was good, the second through fifth were all kinked! After many more attempts I was able to make 4 double bends with reasonable success. On to my hvac lines... the first bend was going well until about 60 degrees, then it started to kink. I was able to salvage the kink and finish the bend. The second 90 worked OK but had a few larger puckers on the inside. To be honest, the radius of the tool is too tight for 1/2" for consistent success. My best guess is add another inch to the tool and it would be excellent! Now after saying that, the 50' tubing kit that I bought from Vevor was less maliable than the tubing that came with my mini-split AC, and that could be part of the problem. I found that going slow and stopping with less pressure about every 10* seemed to help. The bender is an absolute champ on 1/4" and worked well on a few 3/8" bends I tried.

Ce n'est pas à ce que je m'attendais. Très déçu !