Kundenbewertungen für VEVOR Reparaturset für Zaunpfostenanker 6er-Pack Innendurchmesser 8,9 x 8,9 cm Stützpfosten aus Stahl für Zaunpfosten Anker-Erdspieß zur Reparatur von geneigten gebrochenen Holzzaunpfosten Umhüllung

I used two of these supports to secure a fence post that was broken. It made the post solid again.

Best choice I ever made. Was searching for such anchor and found it here. Very strong and durable product. Will buy again

I have only used one of the four so far, and a little bit of excavation was required behind the crooked post. once that was done, the post anchor held the post upright and, as a bonus, reinforced the post close to ground level. Works well, well made, received in good time. Yes, I recommend.

good . As expected. good Price.

These are my second order as they are pretty handy and good, the mistake I made using them into a gravel drive, if you do use them in a gravel drive dig out some clearance room for the dog leg part to sit into, as it went in fine until the dog leg reached the gravel and then I damaged it slightly

die Teile sind zweckentfremdet aber leisten beste Dienste sie werden für eine Verriegelung eingesetzt

A few fence posts started to lean As they ate wooden posts embedded in concrete these offset posts are able to be seated easily. Exceeded my expectations.

These are very solid and heavy duty, worked great for my use although I do agree with other reviews that it would be good if they were a little longer in ground - I concreted in not just hammer into soil and was rock-solid after that. Seem very strong and well made so besides being longer (further in ground) for cases other post is completely loose as a possible improvement (and they do give dimensions so you get what it says!), I cannot fault.

They are easy to be installed provided the ground has no rock or you use a hybrid method. The screws came with the packet are ok but the screws driver is about half inch that his no good.

Title: Anchors break at the welded seams I purchased these fence post anchors and unfortunately they are not strong enough at the welded joints. During normal installation, the anchors started breaking directly along the seams, as shown in the photos. These high-stress areas need to be reinforced and properly welded all the way through. The current welds appear insufficient for the forces the anchors experience during installation. The overall design is useful, but the welding quality and strength of the joints need significant improvement. I would not feel confident installing these for customers unless VEVOR reinforces and properly welds these critical areas.