Kundenbewertungen für VEVOR Präzisions-Gehrungsanschlag für Tischkreissägen, Standardschlitz, 3/4 x 3/8 Zoll, 61 cm Gitter

Qualità prezzo ottimi, calibro ben realizzato e ben rifinito, prezzo supet

The only negative is that this model does not include the extension arm; however, this gauge was very square out of the box, also perfect at 90 degrees, has positive stops for all the popular angles, and the mitre bar adjustment made it fit very snug with no play for the money. I do not believe you can get a better Mitre gauge for the money. This is quality built and definitely will have a home in my shop.

thought I bought the one with the extention

Nice tool, high quality material, and sturdy, fit miter slot. I would like two issues, that need improvement 1. needs to have a UHMW tape attached to the bottom of the aluminum bar, to slide smoothly. 2. to be parallel to the table, you need to place a washer between the part that goes into the miter slot and the top sliding part. I used it on a router table to cut 3/4" slot for T-Slot channel, in large plywood board. using it I could support the plywood that was longer than the size of the edge of the table.

ottimo prodotto con rapporto qualità prezzo eccezionale però le istruzioni sono una nota molto dolente : terminologia inglese non corretta e figure molto sfocate.

Ár értékben teljesen megfelelő. Könnyen kezelhető és beállítható áll. Pl. Hikoki asztali fűrészhez is jól működik.

This is a solid miter gauge. It will get the job done to a high standard. Price/performance is very good. I'd buy again.

Nullissime et dangereux !! Le guide sensé être rectiligne parfaitement est en fonte d'aluminium de très mauvaise qualité, ni droit ni plat et les vis sans tête en acier sensées rattraper le jeu ont défoncé la rainure de ma scie sur table car le guide s'est coincé dedans !! Les vis sans tête se dévissent !! J'ai du le détruire pour le ressortir !! À ÉVITER ABSOLUMENT Mise à jour : VEVOR m'a intégralement remboursé le produit après échange avec le SAV suite à mon commentaire. Merci à eux.

the size and weight of the unit becomes a problem with smaller table saws like dewalt, the T-slot rail is not stable enough to hold the unit and only locks (with coin) in the front creating a lot of play at the end of cuts. I will likely build a infeed and outfeed support to hold it more steady

It fit my saw but i want It on the right side of the blade and I cant flip It around so the measument is matching so for me this is not turned out as a great buy, its been stored under the table ever since buying 😑