Kundenbewertungen für VEVOR Pocket Hole Jig Kit Taschenloch-Vorrichtungssatz 12,7-38,1 mm verstellbar, Vorrichtungs-Taschenlochsystem mit Stufenbohrer Sechskantschlüssel Bohrstoppring Vierkant-Antriebsbit Schrauben

I've just finished 64 pocket holes and it has worked well. It's the first jig that I've bought, and it looks like it will go on doing the job. I taped around the slider to keep it in one spot, so that I didn't have to adjust that to the same depth for each hole. I was drilling near the maximum depth on the scale, and if the drill was a few mm longer, then the end would have reached to drill the far face, but the hole was deep enough none-the-less for the screws to attach and hold well. All the bits that I needed were included.

Well made

This is an adequate tool to get the work done, a bit weak and will flex under heavy use but as a homeowner it'll serve the purpose

The item was priced great and is so much I want off this site but a few hours after ordering the card used was wiped out by fraudulent methods 6k taken in minutes yet this site was the only one used with this card

good product works well

Voor de prijs kan ik niet klagen, maar de gaten waren snel uitgeloterd, na zo'n 20 gaten kwam er al een merkbare afwijking op de gaten. Anders vrij gemakkelijk in gebruik.

This product is not good quality. The holes does not go into the wood, due to the bad bushings. I have made 7 set of holes, and there is a lot of slack between the drill and the bushing. I will have to buy another KREG..

Acquisto non azzeccato! Già all' apertura del pacchetto l'anello di battuta non entrava nella punta, ho dovuto allargare il foro. Dopo pochi utilizzi, il jig per i fori a tasca si è subito deteriorato come si può vedere dalle foto, producendo appunto fori non alla giusta inclinazione lasciando la testa delle viti sporgere dalla loro sede. Avrà funzionato bene per una settantina di fori. Peccato perché ho acquistato tanto da Vevor è non ho mai avuto problemi

Unfortunately this time I'm not satisfied with this product from VEVOR! The quality of the steel is poor and not rock-solid as description.. Both of the bushings and the drill started to wear out on first use and the drill sticks in the bushings and took much effort to get it out. So I had to lubricate with mineral oil every time I use it.

Drill bit stopped drilling after only several holes and appears to have warped the drill changes on jig. Price far below the quality jigs I have used. Did a nice vice grip and driver extension.