Kundenbewertungen für VEVOR Plattenheber bis max. 68 kg, 4877 mm Höhe, Gipskartonheber mit verstellbarem Teleskoparm, Rigipsplatten, Trockenbau-Heber, Panelheber, Hebezeug, Werkzeuge, für Decken- & Wandmontage (Rot)

think of this as disposable. one time use. Quality is ok but its hard to use. The cable used to wind up the lift does not wind right. Its not aligned with the wheel used to wind it. So you have to pull it to the side to get it to wind

Cela ne convient pas et je n'arrive pas a le retourner...Pour un remboursement

Overall it's a pretty good lift. Came quickly, setup wasn't too bad overall it does what it supposed to do. I've used other lifts, and maybe they are only for 8' ceilings but I found a stark difference between the two. On the one I'd used before, it was at a comfortable height to put the drywall on to the lift, maybe waist height. flatten to horizontal and lift to the ceiling. Easy. This 16' lift, because it doesn't have enough telescoping sections, has to be loaded over your head, which is pretty awkward, to say the least. I can't imagine using this for anything over an 4x8 sheet. Especially if you are hanging it solo. Maybe they are all like that out there, but I can't imagine that this design is the standard. Seems like getting it lower would be much better to work with.

Came with no cradle lock ,so it spun freely while trying to load drywall and you have to lift sheets over five feet to get them on lift

Lyft was way too tall to load drywall into completely useless for one person

This is a very cheap version of a good one. The leg design allowed the unit to fall over. The solution was to tie wrap the leg holders in place. And the table is extremely weak allowing the item on it to tilt so much that the item on it slides off prior to reaching the ceiling. I would never recommend this item to anyone

Very poor quality got to lift drywall to far in height to get it on the hoist very cheaply made.