Kundenbewertungen für VEVOR Plattenheber bis max. 68 kg, 3353 mm Höhe, Gipskartonheber mit verstellbarem Teleskoparm, Rigipsplatten, Trockenbau-Heber, Panelheber, Hebezeug, Werkzeuge, für Decken- & Wandmontage (Gelb)

What can I say. Quality equipment and a great price.

Works well for average use. Hung 100 sheets drywall and 50 OSB with it so far. All has held up good less the crank wheel is slightly bent on the bracket. This could have been made slightly more heavy duty. But all in all great for a normal home owner or small contractor.

The whole frame arms & legs are heavy gaged steel,. Very sturdy when lifting in high places. Various ways to adjust arms Etc.,. Easy to adjust quickly. Fast fre shipping. Good product as always.

Great purchase. Very well built and designed.

The product itself is good and the overall quality is decent. The release wheel isn’t great, but it is functional and gets the job done. ***BUYER BEWARE: If you’re working with 8’ ceilings, I would NOT recommend the 16’ model. It is extremely difficult to use because you cannot load the drywall close to the ground. You have to lift the sheet more than 7’ off the ground while keeping it basically parallel to the floor. There simply isn’t enough clearance to side-load the drywall and then rotate it into position. I really wish I had purchased the 11’ model instead. For standard 8’ ceilings, I think it would be much easier and more practical to use. If you are doing vaulted ceilings would work great.***

It's a very nice lift. Two things I would change would be a thicker support bar, and a lip on the end of the hold brackets. This alteration would stop the drywall doesn't slip off when the lift is tilted. However, it's well worth the purchase.

Estoy contento con el producto, funciona perfectamente. Aunque hubo retraso con el envío le doy 5 estrellas.

Worked great will be using it on every rock job I get.

great lift but the rods that hold the legs can pop out of the holes and let the leg close and fell over letting the panel land on my foot. I put zip ties on the rods so they could not come out again. i was able to do a 3 man job by myself

When selecting a lift since they were both the same price I figured why not get the 16ft and it is capable of doing more for future possible projects. I just figured that it had another telescopic piece inside that allowed it to go higher. However, that is not the case. in order to reach the trailer height the base itself is 2 feet taller making this lift mostly useless for the project I bought it for with low ceilings. with the low ceiling i can't tip the cradle to load it and we are having to lift the sheetrock little over 6ft in the air to load and then using the lift to just raise it a foot and hold it in place why screwing it down. Totally my fault but mostly a waste of money on this project and most my future projects. Knowing what I know now, i would only consider the 11ft lift.