Kundenbewertungen für VEVOR Palettengabel 1490 x 70 x 230 mm Gabelträger 907 kg Tragfähigkeit Gabelzinken 149 cm Gesamtlänge mit 109,2 cm-Gabelblatt Gabelstapler 495-915 mm

I bought these clamp on bucket forks specifically to use as brush forks for moving and stacking brush on a fence line clearing project and they have been a welcome, inexpensive labor saver for that. I considered the shorter four-tine type debris attachments but preferred these longer forks for the extra reach. By curling the bucket up/back, much of the weight rides closer to the bucket itself in kind of a cradle between the forks and a backstop that I made to fit in the provided upright slots. However, by using the backstop slots the reinforcing chain slots are not open for heavier flat-carry loads. Oh well, the bucket I'm using is fairly heavy duty and haven't noticed any bending so far under modest loads, and I plan to keep it that way. Also, having enough rear counterweight on the tractor is important for safety since the load is farther out front. My main complaints are that I'm having to re-tighten the clamps regularly (with a short piece of cheater pipe for enough leverage) and I'm concerned about the threads stripping out over time. Also, the forks will move out of alignment fairly easy if much side pressure is applied. The middle stabilizer bar does help somewhat to keep the forks aligned but the wing-nut set screws are dinky and also need periodic re-tightening. I did consider a set of dedicated quick-attach pallet forks but just wouldn't use them enough to justify the cost difference and actually need the extra forward reach that these forks provide. So, by keeping these clamp-ons tight, going slow and deliberate, and approaching the loads as straight-on as possible, I've been able to move/stack more brush for burning faster than my back could ever tolerate. Your needs may differ, good luck!

Product as described. Functions well on my Deere 1023. Shipping / tracking was VERY BAD! It took longer than expected to arrive.

Compression plates won't stay in allowing forks to move around on the bucket because you can't tighten them up enough. But it works

It work

They are a little flimsy but work ok for what I need to do.

not to impressed with this forks. don't stay in place

Do not like them. They are not easy to keep in place on your tractor bucket. You really need to use channel locks or another tool to tighten down the L bolts. The Yellow plates that your supposed to place between the tractor bucket and the bolt, moves around to easily which makes it move out of position when tightening down. When I get enough money saved I would just buy the quick attach pallet forks. I have bought a lot of items from VEVOR and have had great success with them, but this is one I WOULD NOT BUY Again or recommend

These are not 60 in Long there 42 inches long. If you need them to be 60 in long do not buy them. Once you have them there's no way to return them without paying more money and shipping then you paid for the dumb things. So I'm stuck with forks that don't work for the intended purposes that I purchased them for.

Do not buy. I regretted buying. Asked for a refund and got a partial refund to keep item. Do yourself the favor and buy the pallet forks that are attached to the 3 point coonection to your tractor.

Absolute junk. Dont waste your money