Kundenbewertungen für VEVOR Palettengabel 1490x100x230mm Gabelträger 1814kg Tragfähigkeit Gabelzinken 149cm Gesamtlänge mit 109,2cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

It has met expectations for the light duty projects we bought it for but one of the bolts was broken out of the box. We fixed it but quality could have been better.

Nice bucket forks, would buy again. They are a good call value for the price. Nice price point to get yourself started

We'll built with good welds, I did have to replace the hardware/bolts for tightening them to the bucket, they bent the first time I used them , other than that they work great for moving pallets or round bales

Worked great right out of the box. saved the day a couple of times Already!! a good purchase for my needs

Good product, fast shipment. I was well satisfied with the forks but I wish I had the cross bar with it.

I feel the forks are useful but could use improvement. I would suggest a hex head on top of the hand clamp. This would enable easier and more secure contact to the bucket. The forks lift well but can work loose as you use them/

I bought these clamp on bucket forks specifically to use as brush forks for moving and stacking brush on a fence line clearing project and they have been a welcome, inexpensive labor saver for that. I considered the shorter four-tine type debris attachments but preferred these longer forks for the extra reach. By curling the bucket up/back, much of the weight rides closer to the bucket itself in kind of a cradle between the forks and a backstop that I made to fit in the provided upright slots. However, by using the backstop slots the reinforcing chain slots are not open for heavier flat-carry loads. Oh well, the bucket I'm using is fairly heavy duty and haven't noticed any bending so far under modest loads, and I plan to keep it that way. Also, having enough rear counterweight on the tractor is important for safety since the load is farther out front. My main complaints are that I'm having to re-tighten the clamps regularly (with a short piece of cheater pipe for enough leverage) and I'm concerned about the threads stripping out over time. Also, the forks will move out of alignment fairly easy if much side pressure is applied. The middle stabilizer bar does help somewhat to keep the forks aligned but the wing-nut set screws are dinky and also need periodic re-tightening. I did consider a set of dedicated quick-attach pallet forks but just wouldn't use them enough to justify the cost difference and actually need the extra forward reach that these forks provide. So, by keeping these clamp-ons tight, going slow and deliberate, and approaching the loads as straight-on as possible, I've been able to move/stack more brush for burning faster than my back could ever tolerate. Your needs may differ, good luck!

Handige vorken voor in de laadbak, Bestel wel de afstandhouder er bij, als je zelf er niets voor kunt maken.

Delivery man was great product good quality good price easy to use haven’t tested them too much yet butthonk they will be great

These came in handy when we had material delivered to the farm. They will tend to losen after some use so keep a rubber mallet close by to tighten them back. The brace is great for setting the width, but I found it takes away from the depth when picking up pallets. I'm pleased with them for the occasional use.