Kundenbewertungen für VEVOR Palettengabel 1490x100x230mm Gabelträger 1814kg Tragfähigkeit Gabelzinken 149cm Gesamtlänge mit 109,2cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

These 4000 lb. pallet forks should have come with a stabilizer bar to limit side to side movement, the same as the smaller forks. Also, the screw down rods (2 each fork) would be much better with a nut welded to the plate and the rod would then screw down into the nut. As it is the nut is attached to the screw rod, and as soon as the nut reaches the plate, the whole plate slips and slides sideways. This causes paint to be removed from the plate and constant repositioning of the plate while tightening.. This would not happen if the nut were attached to the plate as the rod would hold the nut and plate in place.

They work great for the price. I wouldn't push them too hard but I have lifted over 1000# without an issue. Would buy again for the price.

Pallet forks are well constructed and very solidly made Unfortunately, had trouble mounting on our tractor bucket being impossible to secure without using a pice of plywood under the clamp both to stop it slipping when tightening The forks could really benefit from having a connector bar between the two to stop side ways movement Other than that have been quite useful but need to stop and tighten after a few uses

Die Palettengabel an sich ist echt super, aber beim Service gibt es große Probleme. Wenn man sich an den Service wendet bekommt man manchmal Nachrichten in Englisch und dann wieder in Deutsch und dann nicht einmal von der gleichen Person. Dies verursacht ein großes Durcheinander. Als Fazit: Die Palettengabel ist super, aber der Service ist ausbaufähig.

Price was lowered by $27 one week later should have waited to purchase this item and saved some money or maybe they could credit me on my account.

The center bar broke right away other than that work well

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

10/26 fourche 3 point. Ces Cat1 alors fait pour petit trateur. Assez solide. Mais les attache du bas son trop basse et ne dessans pas assez. Je doit le modifier! Kubota BX23S 2022

Prima aan gekomen .Alleen ontbreek er een pen voor de hefinrichting Jammer moet die gaan kopen hier op het drop hoop dat ze er een hebben

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times