Kundenbewertungen für VEVOR Palettengabel 1490x100x230mm Gabelträger 1814kg Tragfähigkeit Gabelzinken 149cm Gesamtlänge mit 109,2cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

Do not buy. I regretted buying. Asked for a refund and got a partial refund to keep item. Do yourself the favor and buy the pallet forks that are attached to the 3 point coonection to your tractor.

Absolute junk. Dont waste your money

Bestaat uit 2 pakketten, slechts 1 pakket ontvangen, tweede is blijkbaar terug gestuurd naar de handelaar wegens beschadigd onder de baan. Was ook niet duidelijk dat het om twee pakketten ging, dus bij aankomst 1ste al verwarrende situatie. Beter had geweest dat de handelaar direct het tweede pakket had nagestuurd, ipv geld terug en opnieuw te moeten bestellen. Wel geld terug gekregen, wat prima is, maar dus geen werkbaar geheel, de vorken liggen daar nu ...maar vertrouwen kwijt om terug te bestellen ...Immers als je betaalt moet je ook je 3-code meegeven en dat vonden we al scary.

Teleurgesteld. Er is maar 1 pakket geleverd en we hebben dus een incomplete vorkverlenging .We krijgen lastig contact met de klantenservice. We zijn al weken over en weer aan het mailen maar tot nu toe geen oplossing.

I’ve bought a lot from vevor and was happy with products these were a waste of of money no way are they going to stay in position or stay on real heahache

Its hard to keep them for moving back and forth you can’t tighten them enough t on keep them from sliding under pressure

The bolt down clamps are way too cheap made. If you have a decent cutting edge on your machines bucket, it won’t clamp down enough

They ok not to good on your bucket..

I purchased these forks to lift pallets and other things on my Massey Ferg 1742 tractor. They work OK, but it is an absolute pain to get them attached and oriented properly, and despite my best efforts and strength, they will still shift under heavy loads. They are definitely built with solid metal, though the welds are not stellar. They weigh a lot, so be aware 1) when the package comes and 2) when you are fitting them. I absolutely HATE the 90 degree, 4 inch long arms on the top of the tightening bolts, because you sure as heck are not hand-tightening if you think you will keep the forks secure/in-place. After hand tightening, I have to use an open end wrench on the 90-degree and then a 1 1/4" open end to tighten the adjustment nut on the bottom before it has any chance of not moving (but it still will). Also, the stabilizer bar that goes between the forks is helpful, but when moving pallets it has to be all the way back to the stops, near the bucket, so it is only moderately useful. Overall, I am satisfied with the performance based on the cost, but don't kid yourselves (or watch the paid youtube reviews that make it look as smooth as silk), these forks are a challenge taking on/off and are not anywhere near as stable as a dedicated fork attachment.

Forks are definitely heavy duty, can be kind of tough to tighten and the stabilizer bar that came with it is useless due to the wing nut being stripped upon its arrival to me, tried to get it out and could not budge it. The head of the wing but just ended up spinning, welded it together again and tried again, got it out 1/4 turn and it broke the weld.. have not tried to contact vevor about it as I have a feeling nothing will get done.