Kundenbewertungen für VEVOR Palettengabel 1090x70x230mm Gabelträger 907kg Tragfähigkeit Gabelzinken 109cm Gesamtlänge mit 76cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

Forks great just dont fit my bucket well because of step on bucket. Other than that no problem If bucket was flat would mount great. I just got to build something so they will clamp more securely.

These 4000 lb. pallet forks should have come with a stabilizer bar to limit side to side movement, the same as the smaller forks. Also, the screw down rods (2 each fork) would be much better with a nut welded to the plate and the rod would then screw down into the nut. As it is the nut is attached to the screw rod, and as soon as the nut reaches the plate, the whole plate slips and slides sideways. This causes paint to be removed from the plate and constant repositioning of the plate while tightening.. This would not happen if the nut were attached to the plate as the rod would hold the nut and plate in place.

Pallet forks are well constructed and very solidly made Unfortunately, had trouble mounting on our tractor bucket being impossible to secure without using a pice of plywood under the clamp both to stop it slipping when tightening The forks could really benefit from having a connector bar between the two to stop side ways movement Other than that have been quite useful but need to stop and tighten after a few uses

Die Palettengabel an sich ist echt super, aber beim Service gibt es große Probleme. Wenn man sich an den Service wendet bekommt man manchmal Nachrichten in Englisch und dann wieder in Deutsch und dann nicht einmal von der gleichen Person. Dies verursacht ein großes Durcheinander. Als Fazit: Die Palettengabel ist super, aber der Service ist ausbaufähig.

Price was lowered by $27 one week later should have waited to purchase this item and saved some money or maybe they could credit me on my account.

Love these forks. I also bought the fork extensions, vevor needs a set fork the bucket forks. I modified mine. See the photo below.

10/26 fourche 3 point. Ces Cat1 alors fait pour petit trateur. Assez solide. Mais les attache du bas son trop basse et ne dessans pas assez. Je doit le modifier! Kubota BX23S 2022

Prima aan gekomen .Alleen ontbreek er een pen voor de hefinrichting Jammer moet die gaan kopen hier op het drop hoop dat ze er een hebben

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.