Kundenbewertungen für VEVOR Palettengabel 1090x70x230mm Gabelträger 907kg Tragfähigkeit Gabelzinken 109cm Gesamtlänge mit 76cm-Gabelblatt Gabelstapler 495-915mm Einstellbar Gabelstaplerzinken Frontlader Palettenrahmen

Forks are good but the bolts that clamp on the bucket bend very easy :( Maybe user error but I'm sure the were secure before I moved the logs and pallets Welds on nuts broke so maybe that was the problem and it happened on both forks at seperate times

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate

I did t rate it hi because its not strong enough for my use. If you're just going to make straight pics its fine but it twists easily and comes apart easy. I will find a stronger one. I wasted my money on this one

I would not recommend these. The the bolts are soft and had my first use. They actually bent. Those need to be re-engineered with something stronger. Really can't use them for pallet work. They just don't have the ability to stay on the bucket good enough for any amount of weight, but that's significant. Now they are handy for hand stacking things like 2x4s, small logs etc. But in no way replacement for actual pallet forks to be used as a tractor

I would not by again. Weld holding stabile bar broke 1st time I used them to pick up 4 empty wooden pallets. Very disappointing.

The clamps do not stay tighten, not a very good set up. When lifting, the screws become loose and slides off my bucket, if you’re needing forks, just buy an actual pallet fork attachment. I would not recommend these.

Solide mais difficile a mettre en place a cause des vis de serrage qui déplace latéralement quand on les serre a fond

Wish I had got the 4 prong one