Kundenbewertungen für VEVOR Nietmutternzange-Set Blindnietmutternzange 410 mm, Nietenzange 13 Sätze von Muttern & Dornen, Nietmutterwerkzeug M3 M4 M5 M6 M8 M10 M12 Profi Handnietzange, Nietmaschine Gewinde Nieten

First time using it looks real nice didn’t work worth a hoot first one I did it worked second one look at the pictures trying to get it out. Don’t know exactly what I’m gonna do now but it just broke second one putting in. have pictures of tool and the one I did.

Lower handle is way too close to what you’re working on when the rivet nut is fully seated. The nose needs to be longer if you’re going to get at it from a 90 degree angle.

l'outil est deja endommagé

Ved ikke hvordan den virker Jeg har ikke modtaget den 🤷‍♂️🤷‍♂️

Have bought two of these the first one stripped out on first use tried to return with no luck the second rivet nut driver work as it should.

I purchased the 16” semi automatic tool because I have a big project to work on. Unfortunately The slide in the tool is made out of very cheap metal and after the first couple of nut zerts installed it became very difficult to reset the tool for the next use. I would not recommend this tool only because of the internal slide is junk unfortunately because the rest of the tool works phenomenally! I don’t know if vervor will accept a return because i have used it, this is the first thing i bought from vevor that i have been disappointed by. In the photo the cork screw looking piece in the middle is the part that is bad

It worked pretty well. Handles need to be a little longer for the larger zeros. The threads pulled out of the nose of it after installing 8 3/8 nut rivets. I will be asking for mine to replaced or a refund

Like the kit but not as user friendly as I hoped and directions are weak at best. My 1/4” die broke already after only 2 usages.. overall it’s a decent kit but I feel that the short time I have had the kit and little usage it should not be broken already!

Tried to use once. Wouldn't cinch the nut rivet to the piece. Wasted 3 nuts trying. Material was ¼" thick. Don't know if it was to thick or what.

The tool arrived quick enough, looks well made. I used it to repair stripped threads in my snowblower. I used the 1/4-20 rivnuts. The first one worked perfectly, the remaining 5 not so good. After compressing the rivnut I couldn't unscrew the tool easily