Kundenbewertungen für VEVOR Mobile Basis, 1500 lbs Kapazität, einstellbar von 18" x 24" bis 26,5" x 31,5", robuste universelle mobile Basis mit Schwenkrädern, für Holzbearbeitungsgeräte, Bandsäge, Elektrowerkzeuge, Maschinen

I had a base for my table saw but it wasn't built strong enough. It used 4 metal corner pieces with wheel casters held together with 2x2 lumber. This base is a beast. Easy to put together and very well built. You can adjust the length and width to suit your machine. My table saw weighs about 200 to 250 lbs. This will make it a lot easier to move around in and out of the garage for work around the house.

Super produit m'ayant permis de transformer mon établi pliable en établi à roulettes avec dessous un espace de rangement.

Bought to put my 30 year old table saw on to more easily move it around. Install instructions are porr as with most vevor products. Easy to figure out Could use about 4 more bolts to hold the frame together better.

Worked out great for my planer thicknesses. I was easily able to cut down two of the bars to make it fit my machine.

Very happy with this. Moves my bandsaw around without an issue. It's solid and tools smooth. I recommend it.

Kjøpt for enkelt å kunne flytte på en bordsag. Solid kvalitet og lett å bruke

facile à monter, solide, et trè spratique

Just finished putting this together. Instructions were just OK... photos are WAY too small, otherwise ok. Packaging was excellent with all metal parts even bubblerwrapped. The steel components are very well painted and seem very sturdy. The "tires" on the four wheels are not plastic but a "rubbery" material that has some give - thus, the unit rolls smoothly and quietly - very nice movement! Improvements: 1) Better photos in the instructions and 2) plastic or rubber caps to go over the threads of the bolt that serves as an axle for the non-swivelling wheels as they stick out right at ankle level and 3) have a thicker plate for the adjustable floor pads to thread through (the tab on mine has at most 2 threads of engagement that hold all the weight on one end (or maybe weld a nut onto that tab to get more like 5 - 6 threads engaged)) Overall a very solid unit and feels like very high quallity when assembled. Would buy again. (and to help with the minimal thread engagement on the adjutable "feet" you could put the provided locking nut BELOW the table rather than above the tab as show in the instructions)

Makes my Bandsaw easier to move

It is well made and fairly easy to assemble. I would have created a rectangular square hole guide. E. G between 15.5 and 17 use hole ...That way it would be faster. On a related not it should have either a solid base, or a larger corner support for mounting the base. It can still slide around on top of the support. An alternative would be some large screws that pushed in on all sides of the base using the holes on the 4 sides. I'll probably build something to hold it still. Finally, the base is angled when set up for moving. I would have like to see the design keep it level and raise and lower floor stops, not the whole frame. It works but when you have a 500lb top heavy drill press it's a little never racking to roll it around on an angle.