Kundenbewertungen für VEVOR MIG-Schweißgerät, 160 A Welder, synergetische MIG-Schweißmaschine, 4-in-1-Gas/MIG/MMA/Lift TIG-Mehrprozess-Schweißer mit IGBT-Wechselrichtertechnologie und LCD-Bildschirmanzeige

Funkar bra Har bara svetsat med flux tråd men det funkar över förväntan. Har inget att klaga på. Bra köp

Chegou em perfeitas condições e 2 dias antes do prazo previsto. A máquina trabalha bem e é muito bem construída.

Nach den ersten Versuchen, war ich hellauf begeistert saubere Nähe.

I'm a welder and a blacksmith and for what im using this little weder for its great. I would definitely recommend it to someone else to purchase.

Fonctionne tres bien comme Mig...Je n ai pas encore essyer les 3 autres fonctions mais ca devrait aussi bien alleré

Very good working welder,never welded before, finished my job with no problem.

Fast shipping, nice product, will buy a plasma cutter next, no need for 220v

Maschine VEVOR Pro MIG-Schweißgerät, 200 Ampere habe schon ausprobiert ,was soll ich sagen , SUPER !!!

This is a great little welder, has done everything ive asked of it. Built pipe fence with it and various other items around the farm. I recommend it.

if i could give this thing 10 stars i would! while i find it difficult to believe that it is capable of putting out 250amps running mig, this thing is amazing on all other counts. i have taken on the job of rebuilding the packer section of a new to us, used/abused/rode hard put away wet, trash truck. decided to use this unit to tack weld in all the replacement panels and patchwork which is mainly 3/16" and some 1/4" steel. running straight co2 and .035 e70-06 wire, i not only used it to tack in replacement panels and parts, but also ran continuous beads at times running well over 5 minutes in length with very little time to cool down between runs. this with an indicated setting of between 190 and 210amps output. went through my first 10 lb spool of wire using the first contact tip and nozzle, and i think i can go through another spool with the same consumables. i am not sure i will ever drag out the big old linde or union carbide machines again, that is unless i need to lay down some heat on thicker parts. for the home owner, diy'er this thing is perfect, for the small shop again you could do much worse, and for the big shop i think it even has a place there when access is limited. when i finish this project this mig is going in the back seat of my work truck!