Kundenbewertungen für VEVOR MIG-Schweißgerät, 130 A synergetische MIG-Schweißmaschine, gasloses Fülldraht-Welder, tragbarer MIG-Schweißer mit IGBT-Wechselrichtertechnologie und digitalem Anzeigebildschirm

I have been welding for almost 50 years and have used a myriad of welding equipment. This welder is not quality equipment nor designed to handle any were near the rated capacity. The mig gun is of very poor quality and only lasted a minutes before is started to melt down. Maybe a hobby type person could could use such a unit very infrequently but as for any mid size project I would never recommend this welder to any one It does not seem as if this was tested at the factory properly. When it did weld it did nice welds but only for a few minutes and the burn back with the wire sticking or melting to the contact tip was horrendous. If you want to learn welding look somewhere else.

Un fil était abîmé dénudé on doit me rembourser j’attends toujours ….. de plus piètre qualité pour soudet

Just received box very badly damaged hopefully nothing inside is damaged also not satisfied with delivery with ups will be in contact very soon when i open the box and test and check everything

Initial troubles with wire feed and the handle not locking in. This was surpassed by the fact that it has a 15 amp plug not a standard household 10amp. Beware the plug difference as you will have to either purchase a converter or get in an electrician to set up another circuit. Both of these add to the total cost making it not so cheap. Vevor helped out, mostly, but it was an inordinate number of emails to resolve these issues. Good system if nothing goes wrong with it. You get what you pay for. Synergic? Don’t get it. Doesn’t seems too responsive.

Príce

Huge fan in supporter of ever purchase tons of things can't beat the price and the amperage at this welder can produce.It is a little difficult to figure out manual settings you have to convert everything for welding charts and amps I've only used the waldor for a couple hours. And I have a little bit of an issue, it seems to have an intermittent issue with either the mid gun or maybe a ground but overall it welds and puts out some amps!

I know you get what you pay for but this was a bad buy. It won’t weld under 60amps. I’ve tried 4 different rods and i none of them make a difference. The stinger was the size of a popsicle and the ground clamp broke already so I’ve had to replace them both. I don’t even want to waste my time trying the tig setting.

La torche n'est pas d'une grande qualité, les éléments ne sont pas bien centrés les uns par rapport aux autres, tubé contact et buse en particulier.

Recomdable para bricolaje

Keine dutsche bedienung, gibt es einen Link? Kann de Fülldraht nicht einfädeln, Transport des Fülldrahtes stockt