Kundenbewertungen für VEVOR Mechanisches Codeschloss mit Einseitigem Tastenschloss (4- bis 7-stelliger Code), Schlüsselloses Türschloss mit Griff & Automatischer Verriegelung, für Haustüren Garagen, Ölgebronzefarben

Lo compré el 20 de agosto, todavia no la he probado pero tiene buena pinta.

Great locks for outdoor gates! Combo on both sides, so someone can’t just reach over and help themselves. The mechanical feature ensures consistent operation without batteries!

Worked well. Thanks

Fast postage, item was just as described.

Je ne l'ai pas encore installée - la serrure est lourde et semble de bonne qualité. J'apprécie la mécanique qui est sans pile. Ma porte est prépercée de 2 trous donc je dois trouver ne solution sécuritaire pour bloquer le trou supérieur. Je ne sais pas si elle resistera au gel

Mounted it on 30mm wide trailer cage frame. Works great.

good lock esey install

Heavy duty! This thing has some weight to it. Seems well built. Took about 10 min to install.

Bonne qualité et facile à utiliser, à voir dans le temps si tous fonctionne bien

For my garage, this is a good substitute for a standard locking set as I no longer need to fetch a key every time I need access. The cost is reasonable and I will never worry about dead batteries. So far, it is working well for my purpose. However, there are some things to be aware of: 1. The code combinations are limited because you can only use each alphanumeric once, and; 2. The order of the code entry seemingly doesn’t matter. 3.. The instructions for changing the code are accurate but the indicator marks can be difficult to make out under poor lighting (or with old eyes), so make sure you “play” with it outside of the door until you are 100% happy with the way it works before you install it. 4. The bezel width just very barely covers an exiting hole for a standard North American lockset, which can make installation finicky on an existing door. You may even need to infill the old lockset hole with a round plug before drilling new holes for this unit. So, for a new door with no pre-existing hole, this would go much more smoothly than for a retrofit, I suspect. It would be nice if the kit included an infill plug for old doors, and maybe a slightly wider bezel for a bit more coverage of old holes. And if you have your heart set on a specific code, be prepared to make compromises. Finally, if your door has a standard rectangular window with plastic trim, there could be some interference with the bezel. I had to trim the plastic molding slightly along the bottom corner to allow the new mechanical unit to fit properly.