Kundenbewertungen für VEVOR 1200 W Magnetbohrer Magnetbohrmaschine 10000 N Elektrische Kernbohrmaschine Industrielle Bohrmaschine 880 RPM mit Max. Tiefe 50 mm, für Schiffs-und Brückenbau Industrie Stahlbau

Bohrt tadellos Kernbohrer 50mm Stahlplatte 10mm

It is a powerful magnet and look forward to getting to work with it.

This is the 2nd mag drill purchase from VEVOR. The first 'yellow' one had some stability issues, which have been rectified on this model. Vertical travel is rigid and holds the bit in precise alignment. It is a single speed with no variability. Magnet retention is good on a horizontal surface but failed on 1/8" vertical steel plate. This may have been due to flex so I can't really fault the mag base? The annular bit set seem to be of good quality and drill smoothly using water based lubricant. Makes smooth cut holes in metal up to 3/8" steel so far with reasonable speed and the motor maintains a consistent speed with moderate loading.

Bonjour, Globalement satisfais Produit conforme au descriptif Livraison au Top difficile de faire mieux ... Seul regret.....n'est pas livré dans son coffret

Qualità prezzo ok Anche perde un po in precisione

Minus the shipping issue I had the srill works fine the issue i have is therse no part manual with # and the vevor don't like replying back to technical questions.

Works very well. I accidentally broke the knots off. They sent me another It seems it was warranty.

Buena relacion previo calidad!!!

Good solid well priced drill. Hand crank it a bit tight but allows for control. Lubricant tank cannot be used in its cage holder when the drill is attached to the side of a post as the tank is below the bit and will not gravity feed. The tank cage fitting could do with some improvements in terms flexibility in positioning the tank a different angles. Overall for its price though, it gets the job done and I’d recommend it for anyone wanting a lower priced option.

It worked for what I needed. It wouldn't work for high precision drilling but it works for my projects. Motor speed control lags causing speed dips under high initial load but does recover. This can be worked around by adjusting tool pressure.