Kundenbewertungen für VEVOR Linearführung Linearschiene 2 Stk. SBR20-1800mm Kohlenstoffstahl Aluminium Führungsschiene mit 4 Stk. SBR20UU-Gleitblöcke Linearlager Lagerblock CNC Teile für 3D Drucker Fräs-/Drehmaschine

3 av 4 kulelager er defekt om mangler kuler

Tutto regolare a parte un cuscinetto che non scorre bene, leggermente difettoso!

Bitte RG an mich schicken Thx Mit freundlichen Grüßen Kr2003@gmx.de Oder die hinterlegte.

Diese Schienen laufen ruhiger als die 1200mm Schienen, für meinen Zweck ausreichend

Die Lager laufen nicht sehr leicht und geben ein Geräusch ab das wahrscheinlich nicht normal ist.

Ok

Good rails but the bearings have a lot of play. I have a lot of experience with this type bearing.

Theses rails work very well. I am using them vertically and they slide down very easily. However, some of the ball bearings have fallen out of the guides, and the guides are partly plastic, which means they will wear out long before the rails do. By the way, how do you order replacement bearings?

Ho acquistato binari nuovi poi controllando il contenuto del pacco mi rendo conto che i binari erano usati

While I have generally been happy with Vevor products, these two items are of surprisingly low quality and design. First of all, all four items arrived bent. The 1800mm guides were 1/4" (6mm) out f flat, raised in the middle. the 1200 mm ones were likewise bent, but only 3 mm (1/8") out of flat. I was able to to mostly ( but not completely) straighten them by placing them between two sawhorses and applying pressure in the middle, but they are too malleable and have to be attached to a rigid substrate to hold their form. I had to buy some extruded aluminum linear rail at great expense to attach them to in order to make them stiff enough. without this, they will easily deform with just a little pressure. But then I discovered the other design defect. I think it likely that many who buy these intend to use them in sets of four with two attached to the sliders on the other two, in order to make a router sled like I wanted to. The problem is that while the sliders are 48mm wide with a square bolt hole pattern at 35 mm (tapped for 6m-10 bolts), the aluminum support for the linear rods are however only 44mm wide with holes at 30 mm. While it is possible to drill additional holes in the support at 35 mm to match the sliders , drilling hols at 35 mm spacing means that the holes intersect the edge of the support making it nearly impossible to drill them at the correct spacing. this problem could easily have been fixed by making the rod support just 4mm wider. Summary: the rods are not stiff enough, and the aluminum support structure is 4 mm too narrow to attach them easily to the sliders on another set in order to make a router sled. My recommendation: don't buy these if this is your intent or you will be sorry.