Kundenbewertungen für VEVOR Kraftstoffkanister, 20 L, Benzinkanister mit Ausguss & Komfortgriff, max. Durchflussrate 6 l/min, Metall-Benzintank für die meisten Autos, Motorräder, ATVs & UTVs, grün, 2er-Pack

The inlet is 32mm diameter. A good battery powered gas pump normally needs 33mm to put in

Great that they are metal versus plastic. Would much rather have the metal spout. Do not like the plastic ones that come on them

The spouts leak more than the previous design but still work ok. Better than the typical plastic can. Vevor is a great brand though.

I bought this from (VEVOR ) four months ago, thinking it will be better than plastic but NO.... These gas cans RUST from inside out. No warranty . This can not be good for gasoline engines. Buy at your own Risk.

Plastic spout broke right off the start Return to the metal ones. That's what my customers ask for

The cans are totaled garbage. They obviously don’t have research and development because I tried to use one to fill my car and the spout noon and improve design. It’s not even long enough to reach into the gas tank. It’s pretty sad. They’re probably only using half the metal the original cans head already they they have expanded enough to dent the cans. The quality is garbage, nothing compared to a real military can.

The spout is just horrible. When the tank is full and your trying to fill a mower the fuel will spill. Hard to fill slowly. The spout gets pushed in and gas rushes out. The mower tank gets full so fast it overflows. Plus no side handle makes it even more difficult to pour and stop the flow. Then the valve creates a vacuum so when it "burps" gas will overflow even more. Added a side handle and replaced the spout just when pouring the gas.

The can is well built and I'm happy with the construction of the base. However, I can't say the same about the spout and seal. It leaks when trying to pour in holding down the childproof button. Ive tired tightening it down as far as it can go, and it still leaks. The spring on the lid popped out on the ratcheting side to tighten down. I feel the plastic and lid seal is poor quality, so if you need to pour out, don't use the childproof spout.

Not a standard Jerry can pouring nozzle it's like a gas can. 1 out of the 4 cans I purchased can't sit flat on the ground. Last it should have side handles so you can pour it easy.

These work and they are cheap. The cans are steel but the screw-necks are molded plastic, so you have to be careful not to knock them around. They have turn-locks to keep from unscrewing, but these fall off the first time you use them. They do have a handy pour-spout that stays closed until you push on it, but it doesn't close after you remove it. If you want to fill a car, you probably need a flexi-funnel or a a VP fuel jug to transfer it to. I prefer the Latvian NATO cans, but they are over $100/ea bought new.