Kundenbewertungen für VEVOR 37,77 ccm T-Pfostenramme, benzinbetriebener Zaunrammer mit 4-Takt-Motor, mit 2 Pfosten-Rammköpfen (55/70 mm), tragbarer 1000-W-Pfostenramme für Bauernhöfe, Ranchzäune, Straßenverbesserungen

The service was fast, but the machine has not been used yet... Weather too Hot!!!

I used it to pound 15 fence post in the ground and had to tighten and put lock tight on then. Otherwise I love the machine

Good product. Easy use. Arrived with transport box broken during transportation. No new parts supplied after weeks of discussion - compensation instead. Customer service again.

Product performs as describes. It is heavy, but that is the reason it performs!

Thank you for the product. Got my fence posts in

One of the best investments you can make, if you have post fences. I had to put in a total of 60 post, both pipe and tbar. 2 hours, 1.5 tanks of fuel. Worth every penny.

This tool saved me many hours of work, and I really could not have done this job without the post driver. I used it to drive 2x6 boards into the ground in front of a lake wall to seal the areas undercut by the lake eroding the soil under the original wall. I tried driving these boards in using a sledge hammer into a heavy clay soil (lake bottom) and was only able to get 8" deep. The post driver was able to get to an average depth of 15 inches. I made an adapter (on 2nd board from right in the picture) to connect the driver to the boards. Like other have noted, using the low speed, just a bit above idle worked best. And when it reaches a point where no further progress can be made, stop to avoid breaking the tool or your work. It is slow but steady. Super easy starting.

used this to drive Lifetime Steel Posts. "How did you a 4" wide post firnin a 3.94" hole?" you might ask. we compressed the post slightly across.the width using 2.5" 5/16" bolts in the top two holes. worked like a champ! and this machine starts with the lightest pull I have EVER seen. it is amazing.

zuverlässig und gut

Pretty decent rammer. Needs a short break in stretch to get full power. Definitely need to adjust the speed control occasionally. Don't run it absolutely full out. Back off a little, you get better results. This rammer is no joke. Heavy. You all better hang on tight to it Need good upper body strength to control it to keep it centered. Only used it on T posts so far, solid results driving 90 posts so far.