Kundenbewertungen für VEVOR Geländer Treppengeländer Handlauf Querstabhalter für Treppen 152,4x89,5cm

Absolutely Brill fitted easily for elderly in laws they stree very pleased with them solid and high quality

Really helpful for my stairs! Thank you!!

J'ai acheté des ancres Red Head au lieu de celles fournies avec l'emballage. Une fois installé, il semble solide. L'assemblage était simple. Temps total inférieur à 30 minutes.

Je craignais que ces balustrades ne soient pas assez solides car elles ne sont pas en fer forgé, mais elles (j'en ai acheté deux, une pour chaque côté des marches de mon porche) sont excellentes. J'ai également peint les balustrades en blanc cassé pour correspondre aux piliers de mon porche, et elles ont l'air fantastiques.

Simple et rapide

I bought this to enclose our front steps for my wife's ageing mother and our grandchildren. The system is rock solid, however all of the screw heads are rusting already.

If the rail was another 10cm longer would be far better and this 10cm would not cost $2.

Although the handrail is generally of good quality and affordable there are a couple of negatives. The website says to drill 13mm holes but the anchors provided are only 10mm and would not hold. I had to purchase 12mm anchors - cost $1.47 each x 8, total $11.76. These fixed the handrail securely. The side screws attaching the rails to the posts are already starting to rust - I will need to use touch-up paint.

The handrail was easy enough to put together as a 67 year old woman I had no problem with that part. However, I attempted to use the provided hardware (bolts, etc.) but they failed to do the job. I made several trips to my local big box hardware store and finally found the solution I needed to complete installation on my stairs. I ended up purchasing Tee Nuts 5/16 x 3/8 x 7/8 IN. The bolt fit perfectly and the bottom of this nut has teeth that was hammered into the bottom of my deck board. Note that I had to pry up my deck boards in order to do this since the hardware provided did not open and secure the bolt. Those had to be removed by hammering those out first. If you can access the underside of your project, then I'd suggest getting the tee nuts described above. P.S. I couldn't upload a pic since my file image was over the size limit. But it does look super nice on my stairs.

Drilling holes accurately in concrete is the hard part of the installation. Use an impact drill and start with a small bit to improve the chance of the hole being where you want it.