Kundenbewertungen für VEVOR Manuelle Fliesenschneidmaschine 35-1200 mm, Fliesenschneider aus Alu mit Laser-Positionierung Doppelspuriger Führungsschiene & Rutschfestem Gummigriff, Präzision für Keramikfliesen Bodenfliesen

The alignement of the cutter on the base is offset You have to align it and drill and grind the plastic at the end of the frame The frame is to soft When you cut and try to press to split the tile, the frame bind and it become hard to split I have to had steel piece under all the lenght the strength the frame After all that it's a good cheap tool

Quality is ok. But the middle flexes to much and doesn't score the tile. Other ones have support there. So I have to push down on the center section. Not fun. Wish I would have returned. Not a good long term solution.

Could not get the laser to calibrate. Not easy to line up. Once lined up it cuts nicely.

The cutter is not square so the laser does not help. To make exact cut, it is necessary to place a tail checking whether the cutting wheel is placed on the top of the intended cut line on the one side of the tail, then on the other side so preparing for the cut takes time and adjustment. Beside of that, the video of the product and the manual attached to the product depict totally different version of the cutter (the real one does not have side supports and adjusted angle ruler). Customer service was not helpful at all so I did not get any replacement, I had to use what I got.

Very good tile cutter but, the laser line it's useless under the sunlight, the alignment can't be relied upon. If it had a decent strong laser line which could be adjusted by user and a decent top ruler that is accurate, easy to see and long enough for large tile I believe it vould be a competitive tile worldwide. I did a decent job with it but by only ignoring the laser line and marking my tiles first using a tape measure. Despite all this if you are not a perfectionist then you will not find a cheaper cutter anywhere. Cheers

Not very well constructed and flexes too much while scoring. Breaks tiles before score is even all the way across. I have had many of these type of cutters before and this is subpar.

Not the best, have to make alot of adjustments to get straight cuts, laser is never aligned with cutter don't bother using laser.

I thought it will be doing well. Is not what I spec. It doesn't cut perfect. Is hard to adjust the cuts, Is not cutting straight.

J'ai acheté la 1200 mm pour des carreaux de 1000 mm. Les tubes sont trop souples au milieu, donc la carrelette n'exerce pas la même pression et le carreau casse. J'ai dû utiliser un disque en diamant et le laser se voit la journée.

Dziadostwo, nie potrafi przełamac płytki 120 cm tylko pękaja w połowie. Nie polecam. Lepiej dopłacic i kupic cos lepszego.