Kundenbewertungen für VEVOR Fliesenschneider 1200 mm Schnittlänge Profi Manuelle Fliesenschneidmaschine, 6-15 mm Schnittdicke Laserführung Präzisions-Fliesenschneider Fliesenschneidmaschine mit Metallschneidrad

First of all, I’d like to say it’s a very good price which obviously means you’re going to get a cheaper product. If you’re just looking to do a couple of jobs this will get you by. It’s first of all the fence isn’t square and the laser beam is quite far off. You have to Jerry rig it to get it straight otherwise it cuts OK

Great for the price, first small job worked great had another small job and would not cut clean. Installed new diamond wheel and had same issues. Had to hand cut all tiles. So for a one and done it works great but dont expect it to be around for the long run.

uyjk

I choose this cutter beacuse it looked as much rigit as possible, unfortunately these two bars are just flexing too much to make constant presssure along whole 120cm cut, also the laser is unusuable because is impossible to align with the cutting wheel, there is casted nipples which direct the laser position with the cutting line, you can only move it in the angles, for delivery and price 2 stars

Worked well on one tile project not the second.

Sigo esperando la pieza q llegó rota en el transporte. Primera y última compra.Mejor en amazón

Der Fliesenschneider ist nicht eingestellt, der Modus ist nicht genau

Dommage que la règle perpendiculaire à la coupe ne soit pas d'équerre ainsi que le laser, ce qui oblige à tracer des 2 cotés du carreau et visé la molette de coupe

I purchased this tile cutter for as I am doing my bathroom tile. The laser wasnt the best to use. Also, the tile saw kept cracking/braking my tile once I got towards the end. You needed to apply a decent amount of pressure for it to break evenly. A few taps didn't work for my tile. I have 5ftx3ft tiles and I wouldn't recommend this cutter for these type of porcelain tiles. Maybe smaller tiles it would work for. I ended up using just a circular saw with a very good diamond blade which made cleaner cuts.

The alignement of the cutter on the base is offset You have to align it and drill and grind the plastic at the end of the frame The frame is to soft When you cut and try to press to split the tile, the frame bind and it become hard to split I have to had steel piece under all the lenght the strength the frame After all that it's a good cheap tool