Kundenbewertungen für VEVOR Fettpumpe 20L Luftbetriebene Fettpumpe 0,6–0,8 MPa Aluminiumdruckguss-Pumpe -20-100℃ Betriebstemperatur, Pneumatische Fettpumpe NPT-Anschluss Schmierfettpumpe Geeignet für 0-3# Fett

bon produit pour le prix manque un manuel pour l'utilisation la pression de l'air a régler est inconnue

Para engrace de camiones. Las gomitas son débiles

This is a simple to use, simple to set up, grease pump. I've used it to fill up a grease reservoir for a machine. This is a good value for the money. Works well with a 5 gallon bucket

A diferencia de una manual esta es mejor. No entiendo mucho de bombas neumáticas pero lo poco q he trabajado con ella , va muy bien. Necesaria en una nave agrícola

Bestpreis für diese Qualität, bei Bedarf werde ich wieder eine kaufen !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Good product

Great unit only fault is the clamps are very poor and are not great to attach to the 18kg bucket . I would buy the unit again if I need a second one

Does not hold a 20L drums of grease, you need to transfer the grease into it manually. Quite a misleading advertisement.

Overall the grease gun seems to function fine. I had issues initially with the gun nozzle pushing way too much grease and the gun trigger being way to hard to pull. I was using it at my compressor output pressure of 130 psi. Once i turned the guns regulator to about 40 psi I have better control. I would still like it to have a slightly higher pressure for some of my excavator's tighter fittings, but increasing the pressure also increases the flow quantity so I am sitting at a middle ground. So that would be a complaint. I can't have the pressure I want unless I have way too much grease come out all at once. The other issue is that the grease container is not sealed. I filled it with 5 gallons of grease and the next day a small puddle is oozing out between the seam of the bottom and sides of the container. I wish I would have known this and I would have run a bead of silicone at the joint before filling it. That would have been a quick easy fix. But Now it is way too much work to scoop all the grease out, clean it all up to calk it. Or if vevor could have just welded the seam more carefully. Overall this works fine for the price but the overall fit and finish if the tool is a bit less then I hoped.

Bucket latching system is no good and will not grease zirks. Modified it to fill autogreasers on equipment