Kundenbewertungen für VEVOR Entwässerungsrinne, Rinnenablauf mit Kunststoffgitter, 14,5x8x100cm HDPE-Bodenrinne, Garagenbodenablauf, 3 x 39 Rinnenentwässerungsgitter, mit 3 Endkappen, für Garten, Auffahrt, 3er-Set

Made of plastic. Hard to get the grate off. They didn’t fasten together very tight. Probably would have connected better exactly level. I had to caulk them together.

I ordered 12 of these and they are solid, but there is no easy way to connect to an existing drain system. I cut a hole in the bottom and then had to use plumbers glue to secure the drain line. It would have been nice if standard drainage pipe would connect to it better. One of them was also broken in shipment, I didn't realize until later since I didn't unpack them right away. I'm trying to glue it back together, but I may not be able to use it.

They look very well made but I haven't installed them yet.

They look great (pun intended). They seem to be sturdy enough for my application However, the locking slots on the base units are too narrow. When grates are installed, they won’t slide to lock the next base unit. I had to Dremel off 1/4” on the first and second pair of slots from each base to allow the grate to slide and lock the next base unit.

Easy install. My garage doesn’t flood anymore. Strong enough to drive a big truck or tractor over with out breaking!!!

These are VERY solid channel drains. I’ve used them in two different locations and they’ve worked fabulously. The ONLY complaint I have: no accessory or connector to allow for 90 degree turns. If they added this, these would be 5stars.

Worked, but i needed to be inventive with fittings as theae are probably standard in china not standard sizings in Ireland.

I installed three of the trench drains and have eight more to install. I was disappointed to find that HDPE plastic is very difficult to glue in. You really need a special welding machine that melts the HDPE and filler rod with hot air. Also, none of the fittings really seemed to fit standard plastic pipe. All were too loose or too tight. I put the three sections together with the slotted covers off, and then mechanically attached 4 inch drain and waste pipe cut to fit inside the discharge end.. I then filled the small spaces left with RTV. Seems to work just fine.

No available accessories that i could find and no instructions. Decent product for the money. End result turned out well

As the saying goes you get what you paid for. I'm not overly disappointed with the purchased but I think there's room for improvement in the quality department. The channel drain itself is well designed but it could stand to be a little bit more sturdier. The connections between the sections also could be a little bit more secure. I ended up having to put metal corner brackets between the sections because they kept on disconnecting and I also used silicone to waterproof the seams. Other reviews you may have read about the size of the outlet to connect PVC or corrugated drain pipe are accurate. I found no elbows for couplings that will snuggly fit the outlet on the bottom of this drain. I modified it to work with other fittings but it's not ideal.