Kundenbewertungen für VEVOR Druckluft Meißelhammer, 4500 BPM Pneumatischer Hammer mit Nadelentroster & 4-teiligen Meißeln mit rundem Schaft, kompakter Drucklufthammer zum Schneiden, Schaben und Abreißen

I used air needle guns often when I worked as a roughneck, and this one is just as good as—if not better than—the commercial models I used back then.

Por el precio que tiene, no se puede pedir nada más, cumple con el uso al que está destinado, no sé la durabilidad a largo plazo, pero no me importa. Una buena herramienta

5star

5star

M’a permis de casser une dalle sans acier à l’intérieur je précise M’a servi également à faire un trou dans le mur sans problème. Je recommande

Rips for its size impressed with the little gun The rust remover or needle tip is cold I'm not sure wasn't pressed with 2 good little tool

Works no problems

Bought this primarily to remove loose rust before applying surface shield to the underside of our trucks to prep them for Chicago winter. I had borrowed a 20+ gallon compressor, but it failed me and didn't run. I hooked this up to my 6 gallon pancake compressor and it ran just fine in 30s to 1 minute runs. That's all I really needed to do my trucks because they're fairly new and taken care of. I also used the hammer to take out stubborn bolt when I replaced struts, and it worked with no issues. Again, used my small compressor and it ran just fine. This is perfect for the garage DIYer/mechanic.

Fonctionne très bien

Todo correcto