Kundenbewertungen für VEVOR Dickenhobel, 330 mm breiter Arbeitstisch, Hobelmaschine für die Holzbearbeitung, Spiralmesserkopf mit 24 Einsätzen, 2000-W-Motor mit 23.500 U/min, Einzelgeschwindigkeit, für Hart- & Weichholz

A megrendelt gyalut most használtam először 1 m deszkákat gyalultam vele az első 8 db deszka nagyon szépen le gyalulta utána 2db kés kieset a csavar feje le eset amivel rögzítve volt a kés.

Contacted the customer service first in two ways, and I gave them one week to reply; nothing so far, so I must come out with the negative review. Firstly, I also ordered the three-blade version with two speeds 5 days ago, but it hasn't yet arrived. - This Spiral-Style Cutterhead is an absolute abomination. The finish that comes from this doesn't change if you try to swap the blades or reinstall them. Also, they can be turned around only once, with two cutting edges, not four, and they don't sell new blades, and they are made of the same steel, so it will increase the cost of a full change in comparison to a 2-3 blade one. This finish is worse than any normal 2-3 blade machine could give; it also chips against the grain the same way as "normal" blades. Leveling the table 100% isn't possible, so for anti-snipe, you must build your own base from MDF/plywood that is 100% flat, which will eat 20-35mm of height capacity. Same for most tabletop planers, some have a better quality base to calibrate flat. Waiting to get my return information and money back. So far, no reply. Previously, customer service was prompt when I had an issue, and it was solved immediately. Oak board on the picture, did the same with pine, and sanding double the normal with Festool won't fix this even.

When the Wood plate is rough the machine pulls the plate but when the plate is smooth it can't pull (it starts to slip)