Kundenbewertungen für VEVOR Dachrinnenschutz, 12,7 cm breit, Aluminium-Blattfilter, selbstgemachte Dachrinnenabdeckung, 26 Stück, 31,7 m Gesamtlänge, φ 4 mm Lochdurchmesser und 0,5 mm dick, passend für jeden Dachrinnentyp

The rain gutters are 4 inches impossible to find 4 inch covers so about 5 inch aluminum bent 1 inch chin and they work just fine

matériel livré tres rapidement conforme au descriptif . A voir ultérieurement pour sa tenue dans le temps, mais l'aluminium devrait me satisfaire.

I installed this onto a new colorbond corrugated steel roof with typical "quad" guttering, where the back of the gutter is lower than the front. It was difficult to install, I had to unscrew the roof sheets so I could predrill holes in the fascia (back of the gutter) for the screws. The stainless screws look pretty but won't stay in the bit holder because they aren't magnetic, so also fiddly. The 125mm version wasn't quite wide enough to fit my gutters so I couldn't sit the front edge on top of the gutter. I got the front edge to fit into the slot in the gutter where the support brackets go, but where there was a bracket I had to cut the aluminium so that the panel would push down into the slot either side of the bracket. If they work well the effort will have been worth it, time will tell.

They are easy to install and are beautiful to look at , the only issue is the holes in it don’t stop pine needles from sticking and piling up .

Guards were good quality and about 1/2 thre cost of big box stores. I had 200 feet of gutters and at 4' long that's up and down, move the ladder 50 times. Oh well, worked out OK. Would recommend .

This 52 piece set of gutter guards was just the ticket I was looking for. I ended up with 3 feet left over on my 1580 sqft house. Although the package was damaged during shipment and lost a bunch of hardware, which Vevor credited me for the loss, the installation was simple. The guards could have been a bit wider, by 1/8 inch, for a tighter fit, as my drip edge covered the back side of the guard and I couldn't use fasteners to anchor them in place. The fasteners did not hold tight, the threads seem to be same size as the self-tap drill. Bottom line, I believe they will work as advertised, decently priced, easy to modify and cut. Time will tell how durable and efficient they are.

The wrong screws are sent with this product. These are self tapping screws and penetrate the gutter without being able to tighten them. Please put the correct screws in.

Was a bit difficult cutting and trimming around corners but other than that, it worked very nice

good product add to buy and additional packages to complete my house. Easy to install.

Tarifs corrects, livraison respectée. La qualité semble être au rendez vous, à voir dans le temps. Avis positif sur ce produit.