Kundenbewertungen für VEVOR Blechbiegemaschine, 1220 mm, tragbarer Blechbieger, Abkantbank, Winkel 0–135 °, Biegekapazität, 20 Gauge kohlenstoffarmer Stahl und 14 Gauge Aluminium, mit Griffen, zum Biegen von Metall

well built very sturdy pretty easy use easy to fold

Nice little brake. Fully adjustable.

Works great, good Price's

Love it. Everything ive purchased crafted by before exceeds the mass produced garbage you find by far. Im slowly replacing Everything i have with Vevor implementation as i never have any problems, issues, or grief with any of their tooling.

Arrived fast and well packaged. Bent up some 2.0mm Aluminium and it just managed to kind of do it, bent one of the handles and flexed the unit a bit. Piece was 600mm across so within the unit, but just not quite able to cope, it worked ok on a 250mm length. So still got it done, but I’ll be using only thinner material or shorter sections going forward.

Works great. Really enjoy the tool for extra projects either for myself or others. Will be buying more products from Vevor

Worked perfectly for make flashing for a chimney repair

Another great product top notch price

Very heavy well built unit for my needs

The overall build and usability of the bending brake is quite good. It is quite heavy and suited for the job. The edges on the base, knife and anvil are all straight and sharp. There are just a few minor craftsmanship and and quality control issues. The first is the handle on the left side does not fit. The shaft on the handle is 9.8 mm, but the hole into which it must fit is only 9.6 mm. While this is easily remedied with a 3/8" HSS drill bit, it should be necessary. The right side fits just fine. The set screw for the knife depth on the left side was almost all the way out. Again, this seems like a minor and easily remedied issue, but it is likely the reason the angle bracket holding the screw on that side is ever so slightly bent. This probably occurred in shipping, but would not have happened if the set screw had been set flush. There is also signs of rusting at this corner, which are apparent at various places on the entire tool. This was present when the tool arrive, and it has been stored in a controlled environment since then. Again, minor and easily remedied. Again, it shouldn't be necessary. And finally, the instructions specify the bending brake should be fastened to the bench with 3/8" bolts. The holes in the base are too small for that. You will need to either use a slightly smaller bolt or drill out the holes to match. None of these issues are show stoppers, and I still highly recommend the tool.