Kundenbewertungen für VEVOR Blechbiegemaschine, 1220 mm, tragbarer Blechbieger, Abkantbank, Winkel 0–135 °, Biegekapazität, 20 Gauge kohlenstoffarmer Stahl und 14 Gauge Aluminium, mit Griffen, zum Biegen von Metall

Looks quite capable enough for DIY work Unfortunately the unit was damaged before packing - Bent right side mounting plate, not that it prevents the unit from operating . A bit anti corrosive treatment at the factory would be a good idea as rust was visible and needed treatment when removed from packaging. Unable to load images due website restrictions.

It looks beefy but it has too much flex in the center. The ends to center are off by several degrees. I would recommend using with larger gauge than recommended.

La base n'est pas au niveau

Handles bent on the first sheet I tried to bend , had to weld on more heavy duty handles, tried to bend a sheet again, found the bend in the middle doesn't bend to the same angle as at the ends

This unit bends material but does not bend 20 gauge steel with out flexing if you bend material wider than 15 inches. Thinner material it works also when the bar flexes the pivot pins come out even after installing set screws that were missing apon arrival. As stated it works on thinner sheet metal but not 20 gauge as stated. I am not returning this unit as I will use it for lighter material but will look for something substantially heavier. The price was good the description needs to be updated is all

Do not waste your money. I guess the old adage of you get what you pay for is true. One of the screws that is used to hold part of the brake down to secure whatever material you are bending was badly bent and could not be tightened. Reaching out to customer service provided no resolution, even though follow up emails stated the issue would be resolved in 24-48 hours. It has been over 72 hours and nothing has been done. If I could give zero stars I would. Customer support does not care, they just want your money. Stay away.

I bought this to bend 14g aluminum sheet and the handles bent first try. I didnt give zero stars becuase other than the handles it seems to built well. Not recomended for the higher end of its limits.

Disappointed especially i buy a decent amount of Vevor stuff. This is garbage. Doesn't work well and already missing a chunk of metal right in the center of bends. I'd like my money back

I bought this to bend 16 gauge aluminum is rated for 14 gauge which is thicker than what I was bending so it should bend it no problem both handles ended up bending on me and it did not make a nice bend needs more reinforcement so the break does not bow under load