Kundenbewertungen für VEVOR Bandsäge, 229 mm, Holzbandsäge mit 373-W-Motor (1/2 PS), 90 mm Schnitthöhe, 300x300 mm Alu-Gusstisch, mit 360°-Arbeitsleuchte, Gehrungsanschlag, Parallelanschlag, für die Holzbearbeitung

The bandsaw worked well and after the third time using it the blade tracked into the guide causing damage and had to be cut in two places to be removed. I repaired the guide and it has worked ok since then. The aluminum guide is slightly bent though. Can that be replaced?

Not that bad but not good enough for me. If you want to cut 2x4 or take advantage of the advertised cutting height, don’t bother. If you only want to cut small things. It can work. I tried to adjust the wheels, stalled the machine. If you cut at a reasonable speed, it stall the machine. Or the blade slips. It’s not good. I mean, don’t even try with hardwood. I couldn’t cut soft wood. i sent them a message and i got a full refund in a decent fashion. I’m happy with the resolution.

Lower door hinges were crooked making it difficult to open the door. Fence too long for table and cannot lock.I had to make a new fence. Door locking mechanism not very user friendly., too long. Blade does not center on table. The blade guard body prevented full forward movement of upper blade guides, I had to cut off a section of blade guard in order to set blade guides properly. It could be a good bandsaw but the above problems were due to poor assembly and very bad design..

Un giocattolo nn lo consiglio, appena l'ho accesa è uscita la lama e le registrazioni sono pessime

Verpackung Topp. Montage problemlos, Geräuschpegel akzeptabel, Sicherheitsschalter gut aber an falscher Stelle. Das schlimmste aber ist: Egal, ob mit oder ohne Vorschub des Werkstücks, eine nicht zu korrigierende, seitliche Abweichung des Sägeblattes von der Schnittlinie tritt unmittelbar nach Sägebeginn auf.

I tried to use a thinner blade to cut more intricate patterns but the saw is almost impossible to adjust for smaller blades. The bearings that are supposed to be adjusted for back side support won't accommodate thinner blades. Works fine with the blade that comes with it but it is a 1/2 inch blade so intricate cuts won't happen with this blade.

la sega ha alcuni particolari poco stabili. la potenza è piuttosto bassa, serve per pezzi poco alti.

Purtroppo non funziona. Non arriva alimentazione all'interruttore. Misurando col tester dal lato IN si misura una tensione di 54 volt fra due cavi marroni che è sbagliato. La 220v si misura fra il cavo neutro blu lato OUT e un cavo marrone sul lato IN. Probabilmente sono stati invertiti i cavi

A megvásárolt gép nagyon gyenge, szinte használhatatlan. Van-e magyarországi szervíz, ahol esetleg be tudják rendesen állítani. Egyébként cserét kérek.

never got item had to fight with vevor for days, vevor sucks ass.