Kundenbewertungen für VEVOR Abdeckungsheber für Whirlpools Hydraulisch Aluminiumrohren 190-250 cm für Rechteckige Modelle, 175-245 cm Breite, 150-300 mm Eckenradius, Selbstverriegelung, 3 Seitenhaken, Abgerundete Kanten

Facile d installation et fonctionne très bien

This works extremely well and was very easy to install. One of the best purchases I've made.

excellent apparatus to remove hot tub cover when in full use. Does exactly what its design to do. Very easy to install

Purchased two for our 8x12 Swim Spa, was worried aboout clearance as the Spa is surrounded by a deck and we only have about 12 inches of clearance from the top of the deck. Was able to make finite adjustmants for a perfect fit and it works great!

The lifter is primarily aluminium, with steel gas struts and stainless steel (304?) fasteners; it should be reasonably weather-proof and looks quite robust. There are some nice finishing touches like towel hooks and plastic caps for the fasteners. I couldn't find any instructions for the one I bought, so assembly was a bit of a challenge. The worst part is fitting the attachment brackets, which are screwed on to the cladding immediately under the lip of the shell; if your spa has cedar cladding you may need different screws to reach the framing underneath. The brackets have cut-outs intended to fit over any aluminium cover strips between the side and corner panels of the spa, but these are likely to be in the wrong place unless the spa has very tight-radius corners. In this case you will probably need to shorten the existing cover strips, use some packers under the screws, or make new cut-outs in the supplied brackets. As they are attached to both corner and side panels of your spa, you won't be able to remove the side panels without removing the lifter should you need occasional maintenance access. Not sure why they say these are only for spas over 175cm wide; our balcony spa is a fair bit narrower than that but I only needed to shorten one of the arms a little. Once put together the lifter works well, there is a lever on one of the gas struts which allows it to be raised or lowered, and locks it in position when released. The cover can be lifted easily by one person and raises to about an 85 degree angle as shown on the promo pictures. The lifter adds about 200mm to the spa width, and although they say it needs 500mm clearance behind, in reality you only need slightly more than double the thickness of your spa cover as a bare minimum. We're very happy with the purchase overall and would have given 5 stars if the fitting had been more universal and hadn't required some minor mods.

Have been operating this lift for 4 months now, works great. Wife and 9-year old are able to operate it too. Was easy to install and will get this type of lift again in the future when needed.

At first I unfortunately had the wrong hot tub lift delivered. I contacted support and they promptly sent me the correct left. I have installed it now and can't say enough about the quality of the product and the continued support and service from Vevor.

Great buy. Functional and space saving. Ideal for single person removal and re covering. Beats the prices at the specialty stores.

Great product, easy to assemble, great quality and great price. Similar item elsewhere are 400$ with 1 suspension, this unit as 2 for half the price. I recommend

The product was easy to install and is made of good quality for the price. The pistons seem durable. My only regret is the design of the lifter. When the lifter is in the up right position the cover is not fully extended over the en of the hot tub. It’s on an angle towards the interio le of the tub. My previous lifter another brand was at 90 dégrée angle on the exterior of the tub.