Kundenbewertungen für VEVOR 72485-PRC Hydraulisches Bremsleitung Bördelgerät 30-teilig Bördelwerkzeug Hydraulic flaring tool mit 45° Bördelkegel / 16 Matrizen & Adaptern für 3/16"-1/2" Kupferrohr

This is really good for copper but when using stainless steel it doesn't seem to work really good try to use it on stainless steel and it didn't work too good

I bought this primarily for the double flare feature, specifically the 3/8'' tube size and wanted to use it on stainless steel tube. That said, the first time I used it the 3/8'' tube just pushed right out of the holding die and didn't produce a double flare at all, just a single flare with a small double edge. Frustrated, I tried it again with the tube protruding further from the die, thinking I just hadn't had it tight enough or the tube wasn't far enough forward. Same result, and this time I'd marked the tube and could see how much it had pushed back out of the die. To make a long story shorter, I put the two die halves into my mill and removed .008'' from each mating face and now it works correctly. I didn't think that should have been needed, but it was, at least for the 3/8'' die set. I haven't used any of the other die sets yet so don't know if this is going to be needed on those as well, we'll see. Anyway, all the dies and the corresponding flare mating tools are in the kit, maybe it needs to be fine tuned a bit, but the price is right, the hydraulic part works really easily and I'm happy, lots of stuff you buy nowadays doesn't even work; all the parts are here, it just needs a little finessing.

Good tool with lots of dies. It's a bit awkward to use and not good for tight places, but it will do a very nice repeatable flare. I'm happy with the purchase.

Die housing broke second Time i use it but replacement come fast. Good price,fast shipping and customer service is awesome.

Once I got it figured out to do a bobble flare, the tool worked great. I know it says it does not do steel lines but worked just fine to make a power steering line that was not available for my truck.

It's decent, if your job is to flare hardlines all day then buy a high quality one for 4 times the price, otherwise this unit works great, for how longbis to be determined

Works great functions like it should dose good flairs a lot easy than the old school way of doing a double end flair

Sturdy and easy to use, solid flares in seconds.

schnelle Lieferung

Tool does all flares but to get perfect result you need to practice a little bit. Pros: Very easy and foolproof alignment of tubing. No need to use a caliper to set an offset for the tubing. Cons: It is quite hard to move the handle to the end of travel. And if you do not do it the flare is not good. The tool must be secured in a large vise. It cannot be used just by holding in in a hand.