Kundenbewertungen für VEVOR 72485-PRC Hydraulisches Bremsleitung Bördelgerät 30-teilig Bördelwerkzeug Hydraulic flaring tool mit 45° Bördelkegel / 16 Matrizen & Adaptern für 3/16"-1/2" Kupferrohr

The tool came fast and was better than expected. I had used a more expensive flaring tool to do some work and was pleasantly surprised that the vevor tool worked just as well for a quarter of the price. All in all I am very happy with my purchase.

Great tool. Almost made break lines fun to make. Very pleased

Pretty good for the price - please read the description carefully - this machine is to be used on COPPER LINES - when using it on steel, it becomes very difficult. (its possible but very finicky)

Great tool for the money. It does have all the necessary capabilities as the high price kit. Only drawback is that on older thicker tubing, it does not flare well. Newer thin wall works fine.

Awesome tool at a fraction of the price of big brands. Careful when using copper line, it’ll crush otherwise very good quality

Wrks gd just make sure you don't f**k up the first time had to recut with supplied cutter wrks ok gd product

Great tool for the price. My only complaint is the bulkiness of this compared to other hydraulic kits. The inserts are quite large, but it still works good.

This is really good for copper but when using stainless steel it doesn't seem to work really good try to use it on stainless steel and it didn't work too good

I bought this primarily for the double flare feature, specifically the 3/8'' tube size and wanted to use it on stainless steel tube. That said, the first time I used it the 3/8'' tube just pushed right out of the holding die and didn't produce a double flare at all, just a single flare with a small double edge. Frustrated, I tried it again with the tube protruding further from the die, thinking I just hadn't had it tight enough or the tube wasn't far enough forward. Same result, and this time I'd marked the tube and could see how much it had pushed back out of the die. To make a long story shorter, I put the two die halves into my mill and removed .008'' from each mating face and now it works correctly. I didn't think that should have been needed, but it was, at least for the 3/8'' die set. I haven't used any of the other die sets yet so don't know if this is going to be needed on those as well, we'll see. Anyway, all the dies and the corresponding flare mating tools are in the kit, maybe it needs to be fine tuned a bit, but the price is right, the hydraulic part works really easily and I'm happy, lots of stuff you buy nowadays doesn't even work; all the parts are here, it just needs a little finessing.

Good tool with lots of dies. It's a bit awkward to use and not good for tight places, but it will do a very nice repeatable flare. I'm happy with the purchase.