Kundenbewertungen für VEVOR Rangierhilfe Anhänger, Anhängerwagen, 544 kg Stützlastkapazität, 460 & 560mm einstellbare Höhe, 50,8 mm Kugel, 386 mm Luftreifen, Karbonstahl, zum Bewegen von Wohnmobilanhängern

Works well very handy to move camper around.

This works well but needs a quicker way to switch height and ball sizes. The ball needs to screw all the way down. And i also tried to use it on a pintle and it goes all the way through. The hight adjustment is just terrible. You need to flip it over and screw the ball in thr opposite side. Only 2 positions. It should have a way to let the pin go through and a wider plate at the top to hold a pintle

Good and ez to use

The product assembled easily, and so far it has been easy to use

1,200 lbs is the GVW, not the tongue weight! Good product, but that typo needs to be corrected. 1,200 lbs is the GVW, not the tongue weight! Good product, but that typo needs to be corrected. 1,200 lbs is the GVW, not the tongue weight! Good product, but that typo needs to be corrected. 1,200 lbs is the GVW, not the tongue weight! Good product, but that typo needs to be corrected. 1,200 lbs is the GVW, not the tongue weight! Good product, but that typo needs to be corrected.

bonne qualité de fabrication pas super facile à utiliser je n'ai pas réussi avec une visseuse !!!!!!

The product is a bargain, but part F did not fit the holes for it. I had to bend it about 2" wider to make it fit. The owner's manual had some mistakes. It said to make sure there was enough gas in the tires, but they are solid rubber, not pneumatic. The "tools needed" just said socket wrench without specifying socket size, and another wrench is needed to keep the bolt from turning when the nut is tightened. Also, the photo is of a combination box/open end wrench, not a socket wrench. Assembly would be easier if the wheels went on last rather than first, as more leverage is needed to tighten wheel nuts, and the product tends to roll around when assembling the handle. An option should be given to supply it with a 2" ball rather than 1 7/8, as 2" is more common.

Good product. Does the job. But I use it with the Hitch ball tube on top of the pin as I need it higher to move my boat. It gets very wobbly but still works. I am going to try to buy a good steel drill bit to make my own hole for the height I need the pin at

A bit weak due to thin metal

Ça semble bien fait. Installé mais non utilisé encore. Le « User Manual » pourrait être plus explicite. Bon achat.